Wiring Diagram

4
Washer Error Codes
Error
Code
Error Description Display
Notification
Next Step
5C High Voltage experienced by motor control board No Refer to test (12)
5D Communication problem with motor control (message) No Refer to test (10)
5E Communication problem from motor control (communication failure) No Refer to test (10)
5F MC is continuously resetting No Refer to test (10)
62 Wash temperature too high No Refer to tests (13 and 14)
66
(on select models)
Heater relay problem No Refer to test (14)
68
(on select models)
Current leakage to ground on heater or wiring No Refer to test (14)
69
(on select models)
Heater open No Refer to test (14)
6A
(on select models)
Heater relay sensing problem No Refer to test (14)
71
(on select models)
Drum water NTC failure. (tub heater) No Refer to test (13)
74 Wash temperature does not increase No Refer to tests (13 and 14)
83 Wrong selector reading No Refer to test (10)
84
(on select models)
Recirculation pump triac sensing failure which stops the cycle No Replace main board
85
(on select models)
Recirculation pump triac alarm which stops the cycle No Refer to test (21)
86 Incorrect UI selection table No Refer to test (11)
87 User interface micro-controller fault No Refer to test (11)
88
(on select models)
Concentrated wash pump triac alarm No Refer to test (22)
91 User interface protocol incongruence error Yes Refer to test (11)
92 User interface mother board protocol incongruence Yes Refer to test (11)
93 Console or main board control problem (incompatible machine
configuration)
Yes Refer to test (11)
94 Main board control problem (incompatible cycle configuration) Yes Refer to test (10)
97 Console or main board control problem (incompatible cycle
configuration)
Yes Refer to test (11)
98 Incompatible motor control/main board No Refer to test (10)
9C User interface configuration problem Yes Refer to test (11)
9E Touch sensor on user interface not responding No Refer to test (20)
H1/B1 Frequency of power out of limits Yes Refer to test (18)
H2/B2 Supply voltage too high (incoming voltage) Yes Refer to test (18)
H3/B3 Supply voltage too high (incoming voltage) Yes Refer to test (18)
HE/BE Control Relay fault No Refer to test (18)
HF/BF Control relay sense fault No Refer to test (18)
F2 Too much soap or wrong type Yes Advise customer to reduce detergent or change to
high efficiency,
type
F4 Flow meter is not running when valves are driven No Refer to test (23)
F5 Load unbalanced No Redistribute load and restart
F6 Control reset No Refer to test (19)
F9 Hot valve warning - hot water and cold water hoses reversed Yes Reverse the water hoses to reduce the risk of water
temperature related problems with the load
C1 Flow meter is running when no valves are driven No Refer to test (24)
Washer Error Codes, continued