Quick Start Guide

IMPORTANT
Please read all safety instructions before using
your new front-loading washer. For best washing
results with your new washer, remember to review:
 INSTALLATION INSTRUCTIONS
 USE & CARE GUIDE
NOTE TO
INSTALLER
Leave these instructions
with the customer.
IMPORTANT
This washer requires periodic
cleaning maintenance. Refer to
cleaning instructions included
with the unit literature.
CAUTION
EXCESSIVE WEIGHT HAZARD
Avoid back or other injury. Use more than one
person to move, lift or tip the appliance.
ELECTRICAL SHOCK HAZARD
Washer must be properly grounded at all times.
REMARQUE POUR
L’INSTALLATEUR
Laissez ces instructions au
client.
Suite de la version française au verso.
NOTA AL
INSTALADOR
Deje estas instrucciones con
en cliente.
Español continua en la pagina trasera.
REMOVE, SAVE & INSERT
EMPTY DRUM
CONTENTS
CAREFULLY
TIP
REMOVE & SAVE
PROTECT
FLOOR
A)
B)
D)
CART FROM
REAR ONLY
DO NOT CART
FROM FRONT
DO NOT USE OPEN
DISPENSER DRAWER AS
HAND-HOLD LOCATION
DO NOT CART
FROM SIDE
DO NOT USE OPEN
DOOR TO LIFT OR
TIP THE UNIT
DO NOT USE KNEE
IN CABINET SIDE
TO MOVE UNIT
2-PERSON CARRYING
STRAPS, FRONT-TO-
BACK RECOMMENDED
UNPACKING & HANDLING
RETURN UPRIGHT
ADJUST
LEVEL BOTH WAYS
CHECK STABILITY,
CORNER-TO-CORNER
A)
LEVEL
B)
G)
H)
A)
DETERMINE
HOT SUPPLY
TURN ON WATER,
CHECK FOR LEAKS
SECURE DRAIN HOSE WITH
SUPPLIED CABLE TIE
CONNECT TO GROUNDED
OUTLET, DO NOT REMOVE
GROUNDING PRONG
TIGHTEN ADDITIONAL
2/3 TURN WITH PLIERS
TIGHTEN ADDITIONAL
2/3 TURN WITH PLIERS
INSTALL HOT HOSE ON HOT
SUPPLY, COLD HOSE ON
COLD SUPPLY (HAND-TIGHT)
INSTALL HOT HOSE ON
HOT INLET, COLD HOSE ON
COLD INLET (HAND-TIGHT)
CONNECT
A04951401 (1511)
NOTE: INLET HOSES ARE NOT INCLUDED WITH PURCHASE. SEE “ACCESSORIES” SECTION IN INSTALLATION INSTRUCTIONS FOR INFORMATION
ABOUT VARIOUS HOSE KITS TO FIT YOUR SPECIFIC INSTALLATION NEEDS.
USE ONLY NEW HOSES,
VERIFY RUBBER WASHERS
ARE IN PLACE (x4)
24” min
(60cm min)
C)
I)
F)
J)
E)
D)
C)
VERIFY ANTI-
SIPHON DISC
IS IN PLACE
OPERATE
C)
B)
A)
B)
REMOVE & SAVE INSERT
HOLE PLUGS (IN BAG)
NOTE
Rubber material in shipping bolt spacer
may need some time to relax before it can
be pulled through holes in back panel.
IMPORTANT
Retain all shipping materials, including bolts, spacers,
foam base and foam plug. Reinstall to help prevent
damage to washer during any future moves.
x 3
x 1
x 4
x 5
x 1
x 7
RAISE
LOWER
USE ONLY LOW-SUDSING,
HIGH EFFICIENCY
DETERGENT.
IF USING POD-TYPE DETERGENT PACKS,
ADD THEM DIRECTLY TO THE EMPTY
DRUM.
TURN ON THE WASHER. SELECT A
HOT WATER CYCLE WITH AN EMPTY
DRUM. CLOSE THE DOOR AND PRESS
START TO VERIFY THE DOOR LOCK
ACTIVATES. CHECK FOR WATER LEAKS
AT ALL HOSE CONNECTIONS AND
ALSO UNDER THE WASHER.