1. SAFETY INSTRUCTIONS------------------------------------------------------------------- 2 2. ELECTRICAL REQUIREMENTS------------------------------------------------------------5 3. PARTS SUPPLIED---------------------------------------------------------------------------- 6 4. OPTIONAL ACCESSORIES--------------------------------------------------------------- 6 5. INSTALLING THE HOOD ------------------------------------------------------------------ 7 6.
Always turn hood on when cooking over high heat
To Reduce The Risk Of Fire And Electric Shock, Install This Rangehood Only With Integral Blowers Manufactured by Chinabest Home Appliance Co., Ltd, Model CTH03-128D.
Anti-Vibration Pad Wall Anchor Short screw M4 8 Wire Nut Cross socket Head Screw M4 14 Side Sponge strip Front Sponge strip 8' extension chimney Elux PN:EHW08X62AS 12' extension chimney Elux PN:EHW12X62AS 14' extension chimney Elux PN:EHW14X62AS Recirculation Kit with screws Elux PN: EHW62RKT 15.
Any wall modifications needed (i.e. support structure, wiring, ducting) must be completed prior to installation of the range hood. Tools Required (not included): Turn off electrical power at service entrance before wiring. Foil backed tape Wiring should enter the back wall at least 20" above the bottom of the hood at height install and be contained within the flue covers. It is best if the wiring is located offset to the right of center to avoid interference with ducting(Fig. ).
Using the dimensions or the template, mark the locations needed for support. Install horizontal supports between the wall studs at all mounting locations . Flex metal ducts are not recommended Using supplied mounting template(Item 15) mark and drill 9 holes in the wall. Drill the holes according to the measured distances from the diagram(fig.
1. Install the Anti-Vibration Pad (Item 9) to the rear of the hood body (fig ). Peel off the backing and stick the sponge strips (Item 7,8) to the front and sides of the upper fan housing as shown in (fig ). 2. Carefully install the hood on the mounting bracket until it rests on the wall. Make sure to check that the hood is centered over the cook-top and between cabinets if applicable before moving to next step. 3. Install mounting screws as shown in (fig ) to prevent tilting and vibrations.
Insert the upper chimney (Item 2.1) into the lower chimney (Item 2.2) from top to bottom (fig. ). Mount lower chimney (Item 2.2) on the range hood (Item 1). Fit the lower chimney (Item 2.2) to the lower bracket (Item 5) using 2 screws (Item 14) by hand (fig. ) then tighten the screws using screw driver(fig.
EHW62RKT 1-800-944-9044 (USA) or 1-800-265-8352 (Canada) (fig. ). Fix the recirculation box to the wall with 2 sets of long screws (Item 11) and wall plugs (Item 10) (fig. ). Makeup Air Local building codes may require the use of makeup air systems when using ventilation systems greater than specified CFM of air movement. The specified CFM varies from locale to locale. Consult your HVAC professional for specific requirements in your area.
. Side View It is recommended to use the range hood while cooking and for several minutes after cooking to reduce humidity and odors inside your kitchen space. Press the fourth time or the Power button to turn the light off. SPECIAL FUNCTION This product is equipped with a heat sensor that will automatically turn the vent fan ON at medium speed when high temperatures are detected (over 158°F or 70°C).
All other servicing should be referred to a qualified technician. Parts and accessories not provided with your hood, or for replacement, can be purchased at www.electrolux.com or by calling 1-800-944-9044 (USA) or 1-800-265-8352 (Canada).
09050102431 A (EN) September 2020