A Warnings It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the instruction book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
General Features and Parts & o STOPPER REMOVABLE SPLASH GUARD SINK FLANGE RUBBER SINK FLANGE GASKET ) GASKET SUBPART fins INDICATING MOUNT NG ) TIGHTENING CUSHION MoT & DISHWASHER SR e MOPER: ELBOW GASKET SCREWS oo s e FLANGE OVERCHARGE {ELECTRICAL ELBOW CONNECTIONS) Dimensions Electrical specifications are on the disposer rating label MODEL “A” “B” MCH “D” D300 75/5” 53/6” 13%e | 6% Some Typical Installations Sin Ale Bowl DOUBLE BOWL, CENTER OUTLET DOUBLE BOWL END OUTLET ) . son APPROX. APPROX. APPROX.
Installing the waste disposer ‘When INSTALLING the disposer, refer to the EXPLODED VIEW on page 3. The installation of this appliance should be carried out by a competent or qualified plumber. Before installing a new disposer, inspect waste pipe. Ensure the drain is clear of obstruction before use. If the dishwasher drain pipe is to be connected to the disposer, it will be necessary to remove the knock out plug from the dishwasher discharge inlet on the disposer.
When using a gasket: Insert the sink flange through the sink gasket into sink opening. Do not rotate the sink flange, once it is seated. From underneath the sink, place the fiber gasket over the sink flange and screw the support ring on to the sink flange. Note There are arrows indicating the correct side to face upward. Do not over tighten, the sink flange will not move when tightened securely.
Operation 1 Turn on the tap Remove drain plug and turn on a medium flow of cold water. Keep the water running so that any ground waste particles wash through the drain. 2 Starting up ‘When you press the control switch the disposer is on and ready for use. 3 Add food waste Put vegetable peelings, corn on the cob(s), rinds, table scraps, seeds, pits, bones and coffee grounds as well as cigarette and cigar bats and soft seafood shells into the disposer ready to be shredded.
Cleaning and Maintenance Important Before any maintenance or cleaning is carried out, you must DISCONNECT the appliance from the electricity supply. Cleaning The disposer is self-cleaning, but you can flush it by filling the sink with cold water, turning on the disposer and removing the plug. While the water is draining throng the disposer, allow the tap to continue running. When the sink is empty, your disposer will be clean. Fig. X.
* If reset button has not tripped * Check plug top fuse and control switch fuse. If the disposer is supplied from a 13 amp socket, plug another appliance i.e. food mixer etc into the socket to check the supply, Also your fuse box or circuit breaker. If the fuses and supply are all intact, contact your Local Service Force Center. + If the turntable does not rotate * Check the disposer for any objectives) such as a nail, metal tab from beverage can, etc. lodged between the table and the grind ring.
Guarantee Conditions STANDARD GUARANTEE CONDITIONS We, Electrolyte, undertake that if within 12 months of the date of the purchase this Electrolyte appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labor, materials or carriage on condition that: * The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.