Installation & Operating Instructions CS 110 160 200 Type C… 825 12 39-12 MO-M 0714
Introduction Thank you for choosing the Electrolux Wine Cellar. Please read the following instructions carefully before installing your new wine cellar. We trust you will be completely satisfied with your purchase. The wine cellar must be installed and used according to these instructions in order for it to operate correctly and economically. Transit damage Data plate Check the data plate, inside the wine cellar at the top left, to ensure you have received the right model.
1. Remove the transport pallet on which your wine cellar rests. 2. Adjust the feet to allow a 30 mm clearance under the wine cellar and verify that it stands in a vertical position in both directions. If necessary, use a spirit level. Electrical connection The electrical installation must be carried out correctly, taking into account all relevant regulations and codes of practice. The wine cellar operates on a single-phased alternating current.
Maintenance We recommend that you keep your wine cellar as clean as possible. Unplug the cellar before cleaning. Do not use any abrasive or strong scented substances. Use a smooth cloth or sponge and light detergent. It is very important to check regularly that the air circulation underneath and behind the cellar is not blocked. Condensation collects in a small cup placed at the back of the wine cellar. The cup has a sponge which helps the condensation to evaporate.
Storing the wine Example of how to store mixed bottle types Bottles should be stored in your wine cellar according to their size (diameters and heights.) Take these differences into account when storing your wine and avoid mixing the bottles. It is important to store bottles on their side in order for the cork to remain in contact with the wine.
Appendix a - Instruction for mounting the handle stainless steel doors 1) Remove the door gasket behind the two holes adapted for the handle. Start in the upper corner and gently pull out the gasket from the slot. Continue down and pass the two holes. 2) From the inside of the door, put the two attached screws (M4x60) first through the door frame (1), then through the distance bar (2) and then tap the screw into the threads in the vertical handle bar (3).
Appendix a - Instruction for mounting the handle GLASS DOORS wooden doors 1) See step 1, “Stainless steel doors”. 1) 2) 2) 3) See step 3, “Stainless steel doors”.
appendix b - Electric diagram - -
