Operating instructions

10 11
Remote handle with motorized nozzle system DOES
NOT have any batteries or light indicator, so DO NOT try
to open the motorized handle.
Changing the remote handle battery*
TROUBLESHOOTING
The vacuum cleaner does not start
• Check that the cable is connected to the mains.
• Check that the plug and cable are not damaged.
• Check for a blown fuse.
• Check if the battery indicator lamp responds (certain models only).
The vacuum cleaner stops
• Check if dust container is full. If so, empty it and clean both the
dust container and the lters before putting it back in the cleaner.
• Check if the nozzle, tube or hose is blocked.
• Check the motor and exhaust lter are clean.
The cleaner stops
The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube
or hose are blocked. Let the cleaner cool down for 30 minutes before plugging it in again.
If the cleaner still does not work, contact an authorized Electrolux service centre.
Cleaning the hose
Clean the hose by “squeezing“ it. However, be careful in case the obstruction has been
caused by glass or needles caught inside the hose.
Note: The warranty does not cover any damage to hoses caused by cleaning them.
Water has entered the vacuum cleaner
It will be necessary to replace the motor at an authorized Electrolux service centre.
Damage to the motor caused by the penetration of water is not covered by the warranty.
For any further problems, contact an authorized Electrolux service centre.
Disconnect the nozzle from the vacuum cleaner tube
with scissors. Use the hose handle to clean the nozzle.
Cleaning the AeroPro Turbo nozzle*
*Only applies to certain models