ECC 1 Bal ancedCD Pl ayer Owner ’ sManual ENG
Illustration 1 – Back panel Illustration 2 – Front panel
Unpacking the ECC-1 Immediately upon receipt of the ECC-1, inspect the carton for possible damage during shipment. The carton and packaging have been designed to provide the safest possible protection during transport of your product. Unpack the unit carefully. Save all packaging materials for future shipment. The contents of the carton 1 piece Electrocompaniet ECC-1 1 piece AC mains cord. 1 piece inspection card.
How to connect your system See illustration 1.
How to power up your system You should always power up your system in the following order: First turn on the ECC-1, and then turn on the amplifiers. When switching off your system First turn off the amplifiers, and then turn off the ECC-1. XLR configurations XLR output: 1 = ground 2 = positive 3 = negative Technical specifications ECC-1 The following technical data were measured on randomised test objects and are typical data.
Important Notice For optimal sonic performance, the ECC-1 should be burned in for a minimum time of 72 hours. If the ECC-1 has been switched off, allow two hours of warm-up for optimal sonic performance. Proper ventilation is important. Never cover the ventilation area. A good rule of thumb is to allow at least 3 - 5 cm (1 - 2 inches) of air sidewise, and 5 – 8 cm (2 - 3 inches) above the ECC-1.
Madei nNor way W W W .ELECTRO CO M PANIET.