AW400 Monaur alCl as sA Ref er enceAmpl i fier Owner ’ sManual ENG
Owner’s Manual AW400 Balanced MONO Power Amplifier Warning: To avoid risk of fire or electric shock, do not expose this appliance to rain or moisture. Verify line voltage before use. Do not remove cover. No user serviceable parts inside. Refer servicing to qualified service personnel. The warranty is void if the product is tampered with by non-authorised personnel. Use only authorised Electrocompaniet service center.
Unpacking the AW400 Immediately upon receipt of the amplifier, inspect the carton for possible damage during shipment. The carton and packaging have been designed to provide the safest possible protection for the transport of your amplifier. Unpack the unit carefully. Save all packaging materials for future shipment.
How to connect your system Please read this page carefully and see page 5 and page 6. Inputs For optimal performance, the AW400 should be used in balanced mode. (ie. the preamplifier should have balanced outputs.) Input configurations XLR input: 1 = ground Diagram 3 2 = positive 3 = negative Outputs Switch the amplifier off when connecting the speakers. Output configurations Diagram 3 Speaker: Red = positive White = negative Please notice: Both outputs are hot.
Connecting the audio components 5 Balanced
6
Warning The amplifier will be warm. Due to the high class A operating point used in the Electrocompaniet design, it is normal that the amplifier feels warm. Proper ventilation will be needed, and the amplifier should not be covered in. A good rule is to allow 1-2 inches of air sidewise, and 2-3 inches above the amplifier. Replacing a blown main fuse Diagram 2 Always remove the AC cord from the Inlet. The main fuse is located in a small drawer in the AC inlet of the unit.
Technical Specification AW 400 The following technical data were measured on randomized test objects and are typical data. All measurements are made with main voltage 120/240 V 50Hz / 60Hz. Main voltage 120 / 240 V. Clipping point of the amplifier is set to a level where total harmonic distortion (THD) is 0.2%. Output impedance (20-20kHz) ............................ Input impedance mono ....................................... Input sensitivity for rated output ........................... Max.
If Service is needed Your dealer will have all relevant information regarding the service station in your area, and will ensure that your unit is serviced with minimum delay. It is our general policy to have your unit returned to you within five working days. This is an average time, and can vary locally, depending on the workload at that particular service station.
Madei nNor way W W W .ELECTRO CO M PANIET.