USER MANUAL OUTDOOR ELECTRIC HEATER EQODETS - SILVER EQODETB - BLACK Thank you for choosing electriQ Please read the manual before using this heater and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 ASSEMBLY 5 ANCHORING TO THE GROUND 7 OPERATION 8 CLEANING AND MAINTENANCE 8 TECHNICAL SPECIFICATIONS 8 TROUBLESHOOTING 9 SUPPORT 9 2
SAFETY INSTRUCTIONS IMPORTANT • • • • • • • • • • • • • • • • • • • • • • • Carefully read the instructions before operating this unit. This appliance is for outdoor use only. Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. Installation must be in accordance with the regulations of the country where the unit is used. If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician.
• The heater is designed to be used at temperatures above -20°C. If it is exposed to temperatures below this, it must be allowed to warm above this level before operation. • Do not attempt to repair, disassemble or modify the appliance. This unit contains no user-serviceable parts. • Always unplug or disconnect the appliance from the mains power supply when not in use, or when moving or cleaning it. Do not pull the cord to unplug the heater. • Keep the heater clean.
ASSEMBLY 5
ANCHORING TO THE GROUND The patio heater can be fastened to solid ground such as a concrete block for security and safety. STEP 1 Place the product in the desired location (concrete surface recommended) in accordance with the safety regulations and user guidelines. Mark 3 points on the ground around the heater as per diagram A. Remove the product to proceed to the drilling step. STEP 2 Using an appropriate drill bit, drill a hole on each point as marked from step one (Expansion bolt is 6mm in diameter).
OPERATION The heater is really easy to use with only 2 switches. Use the switches to select the power output of the patio heater. Switch I OFF ON ON ON Switch II OFF OFF ON ON Power OFF 900 W 1200 W 2100W CLEANING AND MAINTENANCE ATTENTION: Please turn off the unit and unplug from the mains and allow to fully cool before cleaning or performing any maintenance. CLEANING THE SURFACE • Clean the heater with a duster or a soft wet cloth.
TROUBLESHOOTING Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the warranty and may cause bodily harm. Issue No power Odour emission from unit Possible Reason Solution 1. Power cord is unconnected 1. Connect the power cord 2. There is no power from socket 2. Check socket is turned on 3. The power switch on the rear of the unit 3. Ensure the power switch on is turned off. the rear of the unit is in the on position 1. New unit.