TWN4 MULTITECH LEGIC M INTEGRATION MANUAL
TABLE OF CONTENTS 1 INTRODUCTION .................................................................................................................................................................. 3 1.1 ABOUT THIS MANUAL ..................................................................................................................................................3 1.2 ABOUT TWN4 MULTITECH LEGIC M ...........................................................................................................
1 INTRODUCTION 1.1 ABOUT THIS MANUAL This integration manual explains how to integrate ELATEC RFID reader module TWN4 MultiTech LEGIC M into a host device and is mainly intended for integrators and host manufacturers. The content of this integration manual is subject to changes without prior notice and printed versions might be obsolete. Integrators and host manufacturers are required to use the latest version of this integration manual.
3 INTEGRATION INSTRUCTIONS 3.1 GENERAL TWN4 MultiTech LEGIC M may be installed in any host devices, as long as it is operated under the operational conditions stated in the user manual and other technical documents (e.g. data sheet). TWN4 MultiTech LEGIC M is equipped with two integrated antennas. Thus, no antenna installation is required. 3.
3.8 LABEL AND COMPLIANCE INFORMATION Refer to Chapters “Compliance Statements” and “Integrator and Host Requirements” for detailed label and compliance information. 3.9 TEST MODES AND ADDITIONAL TESTING REQUIREMENTS No specific testing method has been defined by ELATEC for TWN4 MultiTech LEGIC M. TWN4 MultiTech LEGIC M has been tested and found in compliance with the specifications noted on the approval certificates and other relevant approval documents.
4 COMPLIANCE STATEMENTS 4.1 EU TWN4 MultiTech LEGIC M is in compliance with the EU directives and regulations as listed in the respective declaration of conformity. 4.2 FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
4.5 RF EXPOSURE COMPLIANCE RF exposure statement (mobile and fixed devices) This device complies with the RF exposure requirements for mobile and fixed devices. However, the device shall be used in such a manner that the potential for human contact during normal operation is minimized.
APPENDIX A – TERMS AND ABBREVIATIONS TERM host device Integrator KDB modular type n/a RFID (reader) module EXPLANATION Also “host” or “host product”. Device in which an RFID module is intended to be installed for operation. Responsible party for the integration of an RFID module into a host device. The integrator might be the module manufacturer, the host manufacturer, the end user or any other third party.
ELATEC GMBH Zeppelinstr. 1 • 82178 Puchheim • Germany P +49 89 552 9961 0 • F +49 89 552 9961 129 • E-mail: info-rfid@elatec.com elatec.com Elatec reserves the right to change any information or data in this document without prior notice. Elatec declines all responsibility for the use of this product with any other specification but the one mentioned above. Any additional requirement for a specific customer application has to be validated by the customer himself at his own responsibility.