PRINTER’S INSTRUCTIONS: LITERATURE, QUICK INSTALLATION GUIDE, CONTROL EXTENDER, ELAN, EL-IO-200 - P/N: 10024524 Rev-CX1 - INK: 1-COLOR - BW MATERIAL: 80 LB. TEXT GLOSS - SIZE: 4.125” X 5.75” - TOL. +/-.
QUICK INSTALL GUIDE Important Safety Instructions: 1. Read, understand and follow ALL safety and installation instructions included in this manual. Failure to follow the included documentation may damage the product and will void manufacturer’s warranty. 2. Follow ALL installation guidelines included with the product.
QUICK INSTALL GUIDE Contents 1. Rear Panel Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 2. Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 3. RS-232 Serial Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 4. RS-485 Serial Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 5. IR Output Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 6. Signal Input Connections . . .
QUICK INSTALL GUIDE EL-IO-200 1. Rear Panel Connections 2. Mounting The EL-IO-200 is designed to mount to a wall, on a shelf, or mount in a structured wiring enclosure with optional mounting bracket. Wall Mounting Relay Connections 2 relays 12VDC 24VAC @ 1A The EL-IO-200 chassis has been designed to allow convenient wall mounting in any orientation. Arrows on the rear panel may be used to mark the location for the screws. Mark the screw locations, mount the screws leaving approx.
QUICK INSTALL GUIDE Shelf Mounting The EL-IO-200 has rubber feet to protect finished surfaces. Set the controller in a location that will allow you to properly manage connected wiring so that there is no tension on the connections. Structured Wiring Cabinet Mounting Mount the EL-IO-200 in a structured wiring cabinet using the optional structured wiring cabinet mount. 1. Attach mounting bracket to the wiring cabinet with snap rivets and washers. 2. Snap the controller to the 2 hooks on the mounting bracket.
QUICK INSTALL GUIDE EL-IO-200 4. RS-485 Serial Connections 6. Signal Input Connections The two RS-485 ports allow connection to Full Duplex (Aprilaire thermostats, for example) and Half Duplex (Pentair Pool and Spa controllers, for example) RS-485 controlled devices without using adapters. The table below shows the T-568A and T-568B color codes and the function of each conductor of the RS-485 ports.
QUICK INSTALL GUIDE For detailed wiring instructions, please refer to the Integration Note and documentation for the connected device. 8. LAN / PoE Connection The EL-IO-200 can be powered over Ethernet (PoE).The minimum PoE requirement is IEEE 802.3at. 42.5 - 57 VDC, 600 mA maximum. Note: The EL-IO-200 can be connected via WiFi, however a wired connection is preferred. 9. Reset Button Press and hold the reset button for 3 to 5 seconds to reset the network settings.
QUICK INSTALL GUIDE Notes 14 EL-IO-200 Notes 15
Limited Warranty Nortek Security & Control ( ‘NSC’ ) warrants the EL-IO-200 to be free from defects in materials and workmanship for the period of two years (2 years) from the date of purchase.