Vertex Series III IC-VJ63-W IC-VJT63-W IW-VJ63-W OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS IC-VJ63-W Vertex - 6” In-Ceiling Speaker IW-D61-W DebutSeries SeriesIII 6.5” In-Wall Speaker IC-VJT63-W III - 6” In-CelingSpeaker Angled Home Theater Speaker IC-D61-W Vertex Debut Series 6.5” In-Ceiling IW-DC51-W Debut Series 5.25”Speaker In-Wall Center Speaker IW-VJ63-W Vertex Series III -Dual 6” In-Wall IC-DT-61-W Debut Series 6.
INTRODUCTION Congratulations on your purchase of these fine loudspeakers and welcome to the ELAC family. Ever since we started in 1926, we have striven to create the very best products available. Our passionate team members are always looking for ways to improve your listening enjoyment. We thank you for making this choice. These ELAC Vertex III Series In-Ceiling speakers are designed to accurately reproduce the full range of music and film sound, while requiring absolutely no floor space.
SAFETY INSTRUCTIONS Use Only As Directed • Observe all warnings on the speaker and in this manual. • Please check the speaker for damage before use. • Carefully consider the proper location before beginning the installation. • Observe the correct polarity when connecting these speakers, according to the instructions in this manual. Location • In-wall speakers should be mounted close to, or slightly above ear level whenever possible. • Allow at least 1.
INSTALLATION Hooking Up The Wires • For shorter distances up to 25 feet, 18 gauge speaker wire will be sufficient. For longer distances, 16 gauge speaker wire should be used. The speaker terminals will accommodate up to a 14-gauge speaker wire. Leave two feet of extra speaker wire at the speaker end to make installation easier. Do not use nails, staples or other metal objects to secure the speaker wire.
INSTALLATION - continued • Attach the speaker cables to the speaker terminals, observing the correct polarity. • Remove the grille from the speaker frame. The grille is held on by magnetic attraction. • With the grille removed, the speaker can be inserted into the mounting hole. First make sure all the tabs are rotated inwards and then connect the speaker wires.
SPECIFICATIONS IC-VJ63-W IC-VJT63-W IW-VJ63-W Speaker type 2-way, rear side open 2-way, rear side open 2-way, rear side open Tweeter Jet Folded Ribbon Jet Folded Ribbon Jet Folded Ribbon Woofer 6 inch (152 mm) Crystal Aluminum Cone 6 inch (152 mm) Crystal Aluminum Cone 6 inch (152 mm) Crystal Aluminum Cone X-Over Frequency 3 kHz 3 kHz 3 kHz Frequency Range 45 to 40,000 Hz 45 to 40,000 Hz 45 to 40,000 Hz Sensitivity 88 dB at 2.83 v / 1m 88 dB at 2.83 v / 1m 88 dB at 2.
ELAC Americas Inc North America Limited Liability Warranty Passive Speakers (No Built-in Amplifier) ELAC Americas Inc. Warrants to the original purchaser that this product will be free from defects and or workmanship for a period of 3 (three) years from the original date of purchase. During this time, repair or replacement of parts will be free of charge to the original owner. (See below limitations.) Shipping to and return from the repair center will be the responsibility of the original purchaser.
