Use and Care Manual

WOOD SLAT WALL
installation instructions:
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear proper protective gear.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
Standard power grab
Adhesive
Small brad nails
Brad nailer or hammer
Quality Paint or stain
Paint brush or roller
Fine sandpaper
Chalk line & measuring
tape
Circular or Table Saw
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• Clean and prep the installation surface and each Slat of any debris with a clean cloth.
• It is highly recommended that you paint or stain the panels before installation.
• It is recommended to use quality and stain for all wood species.
• Make sure the surface and the back of the panel are completely dry before installation.
• Before installing, acclimate the wood Slats in the room where you will be installing them.
• In most applications you will have to trim some panels. Cut them with a standard table
saw or power tool. Sand cut edge ends and clean away any debris.
• Depending on your installation method, use standard power grip adhesive and brad nails.
1. Prep and stain Slats before installing. Touch
up stain as needed after installation.
2. Smooth installation surface with sandpaper
by removing excessive bumps or texture.
Wipe wall clean to clear debris.
3. We recommend laying out the desired layout
before installation as these are completely
customizable and space is up to you. Mark
the installation points using a chalk line or
straight edge and level.
4. Apply a small amount of adhesive to the back
of the panel and secure with small brad nails.
(Follow adhesive manufacturer’s instructions
for proper application.)
5. Once the rst one is installed, repeat step 4
on the rest of the Slats
We Can Help. Call [phone]
www.ekenamillwork.comIndustry leading manufacturer of urethane, PVC, wood, rustic, and metal millwork
FINISHING
NAILS