Installation Guide

FREESTANDING BATHTUB INSTALLATION GUIDE
WARNING: Do not install this product without a complete inspection in case of rough
handling along the shipping route or at the job site. Inspect the tub thoroughly upon
arrival. Make sure every part of the tub is free of damage before installation. If there is
any problem with the bathtub or piping system during the pre-installation inspection and
water test, do not install the unit and contact Eisen immediately. All pre-installed units
must be checked and retightened carefully before installation.
PREPARATION
1. Clean the floor and prepare as flat a
surface as possible before installation.
2. Place the unit on the floor in the
designated installation area. Mark the
outline of the bathtub with a pencil or
pen (pic 1).
3. Measure the drain and waste location
under the unit, and determine the correct
position of the drain pipe (pic 2).
4. Cover the unit with a blanket, cardboard,
or other clean, protective materials so
the unit is well protected during the
drain installation process.
5. Pop-up drain is pre-installed in the
bathtub.
www.eisenhome.com
If any questions or concerns arise, please contact us via email at [e-mail], or give us a call at [phone]