User's Manual

Radio Controlled Rattle Snake
Model Number 38012 (EL322)
Operating Instructions
Introduction
The radio controlled rattle snake is so life-like; it will make your skin crawl!
The easy-to-use radio controller allows you taking charge of the action and
moving the snake forward, left, right and stop. The rattle snake is fully
assembled that is ready for playing with batteries loaded; it works indoors and
outdoors on smooth surface up to 25 feet!
Battery Installation
Controller – Requires 1 x 9V battery (not included)
1. Unscrew and remove the rear panel using a Philips head screwdriver.
2. Insert one 9V battery following the polarities indicated on the battery compartment.
3. Replace the battery door.
Snake – It requires 4 x AAA batteries (not included).
1. Lift off the upper head section exposing the battery door.
2. Unscrew the battery door with a Philips head screwdriver.
3. Insert 4 x AAA batteries following the polarities indicated on the battery compartment.
4. Replace the battery door and upper head section.