AIOT Wi-Fi Module Product Specification EW-7711MAN V1.
Revision History Version V1.
1. General Description Model : EW-7711MAN Purpose: Edimax EW-7711MAN is a highly integrated single-chip low power 802.11b/g/n Wireless LAN (Default: 802.11n 2.4G only) network controller. It combines an ARMCM3 MCU, WLAN MAC, a 1T1R capable WLAN baseband, and RF in a single chip. It also provides a bunch of configurable GPIOs which are configured as digital peripherals for different applications and control usage. EW-7711MAN integrated internal memories for complete WIFI protocol functions.
2.
Category Item Detail Support Model RTL8721DM-VA1-CG V Chipset clock Max 200MHZ V Flash /DDR Flash Size 4MB SPI FLASH V Memory DDR Size 4MB (Embedded) V Operation -10 ~ 40 ﾟC V Storage -20 ~ 60 ﾟC V CPU Temperature Humidity 20~80% (Non-Condensing) 5 V P Comment
ID & ME Category Item ID EW-7711MAN Detail Support Comment V I/O Debug Log Interface V External 2.4G or Dual Band Antenna P Ant.
依據【低功率射頻器材技術規範】 取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻 率、加大功率或變更原設計之特性及功能。 低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應 立即停用，並改善至無干擾時方得繼續使用。 前述合法通信，指依電信管理法規定作業之無線電通信。 低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 7
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Additional testing, Part 15B disclaimer : This module only complied with FCC 15.247 requirements as listed on the grant, and therefore, the host product manufacturer is responsible for FCC Part 15B compliance testing with the module installed. This device is intended only for OEM integrators under the following conditions: (1) Be careful not to exceed the operating voltage of the module, to avoid damage to the module caused by excessive power supply.
