Quick Installation Guide

ManualsBrandsEDIMAX ManualsCamera & Photo2MP WI-FI Bullet Camera

IC-3231GOP

2MP WI-FI Bullet Camera

 Video Services must be enabled in TSC VIEWER.

 Camera setup requires a TSC SERVICE account and the TSC VIEWER mobile app.

 Camera operation requires minimum available bandwidth of 1.5 Mbps.

Download the TSC VIEWER app from the App Store or on Google Play.

Check these settings when you turn on your mobile device’s Wi-Fi and

Bluetooth.

For best result, configure only one camera at a time.

 Make sure the Bluetooth isn’t connected to another device, such as

headphones

 Also, make sure the mobile device is (ringer and speaker should be audible)

a. Turn on your smart device’s Bluetooth and Wi-Fi.

b. Launch the app and sign in with your TSC VIEWER account.

Plug in the power connector. The LED at the down flashes various colors. Then,

wait for the camera’s LED to display BLUE only. This may take a couple of minutes.

a. Login in your account and press Add

CAMERAS at the bottom (iOS) or top

(Android) of the screen.

b. Select the type of camera you’re

installing. The names of the camera

models may vary from the illustration

at right

c. Name the camera and press NEXT.

d. and the camera’s LED to flash BLUE

only

a. Start to scan all

cameras via

Bluetooth.

b. Select your camera

or press Back.

c. Select your Wi-Fi

network or press

Back.

d. Enter the network

password and press ok.

Final setup begins

Summary of content (5 pages)

PAGE 1
IC-3231GOP 2MP WI-FI Bullet Camera Quick Installation Guide  Video Services must be enabled in TSC VIEWER.  Camera setup requires a TSC SERVICE account and the TSC VIEWER mobile app.  Camera operation requires minimum available bandwidth of 1.5 Mbps. Download the TSC VIEWER app from the App Store or on Google Play. 1 Check these settings when you turn on your mobile device’s Wi-Fi and Bluetooth. For best result, configure only one camera at a time.
PAGE 2
When setup is complete, the LED on the 5 camera changes from steady blue, to purple and finally to steady green. The app also displays Successful*. Press OK After setup, at the CAMERAS page and check your newly-registered camera. Touch the preview image to launch a live stream from the camera. *The app will tell you if your need to repeat the setup process. This involves resetting the camera, which is described in the app itself.
PAGE 3
FEDERAL COMMUNICATIONS COMMISSION (FCC) The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User’s Manual. Unauthorized changes or modifications could void the user’s authority to operate the equipment. CLASS B DIGITAL DEVICE STATEMENT This equipment has been tested to FCC requirements and has been found acceptable for use.
PAGE 4
EU Declaration of Conformity English: This equipment is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU, 2014/35/EU. Français: Cet équipement est conforme aux exigences essentielles et autres dispositions de la directive 2014/53/EU, 2014/35/EU. Čeština: Toto zařízení je v souladu se základními požadavky a ostatními příslušnými ustanoveními směrnic 2014/53/EU, 2014/35/EU.
PAGE 5
Declaration of Conformity We, Edimax Technology Co., Ltd., declare under our sole responsibility, that the equipment described below complies with the requirements of the European Radio Equipment directives. Equipment: Wi-Fi Bullet Video Camera Model No.: IC-3231GOP The following European standards for essential requirements have been followed: Directives 2014/53/EU Spectrum : EN 300 328 V2.1.1 (2016-11) EMC : EN 301 489-1 V2.1.1 (2017-02) EN 301 489-17 V3.1.