ECW7220-L_Quick Start Guide-R01

ManualsBrandsEdgecore Networks ManualsWireless802.11ac Dual-Band Wireless FIT Access Point

– 1 –

Quick Start Guide

1. Unpack the AP and Check Contents

ECW7220-L

802.11a/ac/b/g/n

Wireless Access Point

Ceiling-mount accessory

Four adhesive foot pads

Console cable—RJ-45 to DB-9

Documentation—Quick Start Guide (this document)

and Safety and Regulatory Information

Note:

For Safety and Regulatory information, refer to

the Safety and Regulatory Information document

included with the AP.

Caution:

The planning and installation of the AP

requires professional personnel that are trained in the

installation of radio transmitting equipment. The user

is responsible for compliance with local regulations

concerning items such as antenna power, use of

lightning arrestors, grounding, and radio mast or tower

construction. Therefore, it is recommended to consult

a professional contractor knowledgeable in local radio

regulations prior to equipment installation.

2. Mount the AP

a. Mounting on a Wall

Set two screws in the wall 116 mm (4.57 in.) apart.

Slide the AP’s wall mounting slots down onto the screws so

that the unit is secure.

b. Mounting on a Ceiling T-Bar

Position the ceiling-mount accessory clip holders on either

side of the T-bar.

Turn the ceiling-mount accessory until the two clips lock it to

the T-bar.

Slide the base of the AP onto the T-bar accessory until it is

locked in place.

Note:

The ceiling mounting plate supports two different

sizes of ceiling T-bars. The position illustrated above is for

15 mm bars. Use the other position at a 90 degrees angle for

24.5 mm bars

3. Connect Cables

Connect Category 5e or better cable to the Eth0/PoE

1000BASE-T RJ-45 port.

(Optional) Connect a local LAN switch or computer to the

Eth1 1000BASE-T RJ-45 port.

Note:

The Eth0/PoE port connection also provides PoE

power to the unit.

4. Verify AP Operation

Power — on green for normal operation.

Eth0 / PoE — on green for a valid link.

Eth1 — on green for a valid link.

2.4G / 5G — on blue for 2.4 GHz or 5 GHz radio enabled.

E042015-CS-R01

150200001132A

www.edge-core.com

802.11ac Controller-Based Indoor Dual Band Enterprise Access Point

ECW7220-L

Summary of content (2 pages)

PAGE 1
Q ui c k Sta r t G u id e 802.11ac Controller-Based Indoor Dual Band Enterprise Access Point ECW7220-L 1. Unpack the AP and Check Contents b. Mounting on a Ceiling T-Bar 3 ECW7220-L 802.11a/ac/b/g/n Wireless Access Point 1 2 Ceiling-mount accessory 1 Position the ceiling-mount accessory clip holders on either side of the T-bar. 2 Turn the ceiling-mount accessory until the two clips lock it to the T-bar. 3 Slide the base of the AP onto the T-bar accessory until it is locked in place.
PAGE 2
Quick Start Guide 5. Manage the AP from the Controller 1 The AP is designed to be managed from an EWS4502 or EWS4606 wireless controller. For information on AP management, refer to the wireless controller Administrator’s Guide and CLI Command Reference, which are on the EdgeCore web site, www.edge-core.com. Hardware Specifications Chassis Size (WxDxH) 200 x 200 x 36.5 mm (7.87 x 7.87 x 1.44 in) Weight 750 g (1.