Model: GDI-EXSNDXTR01
You should always 1.) Use the ECOXGEAR speaker in accordance with any music or noise rules and regulations. 2.) Properly seal the ECOXGEAR prior and after each use when in humid or water environments to avoid water damage to the internal components. Salt water / air is particularly corrosive. Always make sure that the gaskets are sealed when in a salt water environment and that the unit is properly rinsed off after use. SoundExtreme Layout Backlit Speakers 3.
FCC STATEMENT: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.) This device may not cause harmful interference, and 2.) This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The SoundExtreme does not have an internal battery. It must be connected to an external 12VDC power supply to function. When you install the SoundExtreme to a battery or a voltage regulator on a golf cart, a boat, a quad bike, a UTV, or another vehicle, you need to make sure that your vehicle battery or battery pack terminal voltage is 12VDC. If the battery terminal voltage is not 12V, you will need a DC–DC converter with output 12V.
This device complies with part 15 of the FCC & IC Rules. Operation is subject to the condition that this device does not cause harmful interference (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Controls 1. LED Indicators: Each of the 4 LEDs correspond to different functions: Power, Bluetooth, Mode, and Status. Mounting Brackets 1 2 2. Power Button: Press button to turn the SoundExtreme on / off. 3. Mode Button: Press button to cycle through the following modes: Bluetooth, EcoCast Transmitting, EcoCast Receiving, FM, and AUX-IN. 3 4 5 6 7 8 9 4. Volume Control Buttons: Press to adjust the speaker’s volume. Press and hold to adjust the volume continually. 5.
After the SoundExtreme is connected to your Bluetooth device, press briefly to play, press again to pause. Operations Press briefly to play previous song. Press next song. LED Indicators Press or briefly to get the briefly to adjust the speaker volume. LED: Backlit Speakers Press Press briefly to turn on your speaker backlights. or briefly to cycle through the 4 Party Light modes. LED: Light Bar Press Press briefly to turn on your Light Bar. or briefly to cycle through the 4 Light modes.
Pairing a Bluetooth Device Remote Control 1. Turn on your Bluetooth device. 2. Power on SoundExtreme. “Speaker on, ready to connect” voice prompt will be heard. If the Bluetooth LED Indicator (the second LED Indicator from the left) is not flashing, briefly press to start pairing your device. 3. Navigate to your Bluetooth device’s setup screen, find ECOXGEAR and connect. If the connection is successful, the Bluetooth icon will be lit solid and your SoundExtreme will announce “Your phone is connected.
Listening to FM Radio (FM Mode) Play Music (Bluetooth Mode) Press briefly to cycle through to FM Mode. Press or briefly to tune in a radio station. To “seek” (jump to the next available station), PRESS AND HOLD either button down for a few seconds until it starts to seek a station. After the SoundExtreme is connected to your Bluetooth device, press briefly on the SoundExtreme to play, press again to pause.
EcoCast: Additional Receiving Speakers EcoCast – Broadcast Your Music to Multiple Speakers B x50 A When you have two or more SoundExtreme speakers, you can build a broadcast system by initiating EcoCast Transmitting Mode in one SoundExtreme speaker and broadcasting your music to one or more SoundExtreme speakers in EcoCast Receiving Mode. C D 1. Power on the additional SoundExtreme speaker(s) (Speaker C and Speaker D). Press to cycle through to and initiate EcoCast Receiving Mode.
