Quick Start Guide

Table Of Contents

Bulldog-JW Valve Robot, Model EVC300 Control Module

Quick Start Guide

The Bulldog-JW Starter Kit is a Leak Detection & Prevention

Solution that “Just Works”.

1. Install the Bulldog motor assembly over your water

shutoff ball valve (See Mounting/Valve Install Guide)

2. Connect the Motor Assembly to the Control Module

3. Plug in the AC Adapter and connect it to the Control

Module

4. Position the Sensors in to Leak sensitive locations.

5. Done!

Leak Alarm Reset:

• Click On/Off Reset Button (Speaker)

• Click On/Off Valve Open/Close Button (once or twice)

Adding ELS100 Leak Sensors

• Green ¾ Circle is the Leak Sensor Pairing Button (dotted, ¾

circle with arrow)

• Adding/Pairing Leak Sensors: Click Green Button On/Off, then

activate leak sensor for 2 Beep Cycles

• Click Alarm Reset, repeat above for additional Leak Sensors

Exclude All Leak Sensors:

• All paired Leak Sensors can be removed (Excluded) by holding

green button for approx. 5 seconds until red blink

acknowledgment

Valve Open/Close Button

WIFI Pairing Button

Leak Sensor

Pairing Button

Alarm Reset

Button

PAGE 1
Bulldog-JW Valve Robot, Model EVC300 Control Module Quick Start Guide The Bulldog-JW Starter Kit is a Leak Detection & Prevention Solution that “Just Works”. 1. Install the Bulldog motor assembly over your water shutoff ball valve (See Mounting/Valve Install Guide) 2. Connect the Motor Assembly to the Control Module 3. Plug in the AC Adapter and connect it to the Control Module 4. Position the Sensors in to Leak sensitive locations. 5.
PAGE 2
WIFI Pairing to eWeLink App: • • • • • • • • • • • • Install, setup account and login to eWeLink App The Valve Icon is the WIFI Pairing Button Blue LED is WIFI Status, Slow Single Blink, pause, not paired, not broadcasting Blink, blink, blink, pause, repeat, ready to be paired (Quick Pairing mode) 2.4GHz Network required & Smart Phone should be connected to this 2.4GHz Network If not in pairing mode, hold Valve Icon button for approx..
PAGE 3
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.