User's Manual

ManualsBrandsEcolink Intelligent Technology ManualsElectronicsComcast Xfinity Home Motion Sensor

MODEL URC4470BC0-X-R FLAT PIR 1

ZigBee Home Automation 1.2

Wireless Digital Pet Immune PIR Detector

Installation Instructions

1. INTRODUCTION

The URC4470BC0-X-R is a microprocessor-controlled wireless digital PIR detector supported by ZigBee HA 1.2.

The detector’s features are as follows :

 Up to 15 meters (49.2 ft)

 Uniform Detection

 White light immunity

 Enhanced Pet immunity up to 85Ibs

 Enhanced false alarm rejection

 In normal mode, after detection, the detector goes to sleep to save battery power. It wakes again (reverts to the ready state) if there is no

subsequent detection throughout the following 3-minute period.

 Temperature compensation.

 Tamper protection.

For UL installations: The detector is for use with UL listed control unit only. Pet immunity has not been evaluated by UL.

Figure 1 - MP-841

A. Red LED

B. Green LED

C. Tamper Switch

Summary of content (6 pages)

PAGE 1
ZigBee Home Automation 1.2 Wireless Digital Pet Immune PIR Detector Installation Instructions 1. INTRODUCTION The URC4470BC0-X-R is a microprocessor-controlled wireless digital PIR detector supported by ZigBee HA 1.2. The detector’s features are as follows :         Up to 15 meters (49.2 ft) Uniform Detection White light immunity Enhanced Pet immunity up to 85Ibs Enhanced false alarm rejection In normal mode, after detection, the detector goes to sleep to save battery power.
PAGE 2
. SPECIFICATIONS Detector Type Optical Data Two - Dual element low-noise pyroelectric sensor 18 parabolic mirrors for long range 18 parabolic mirrors for close range Max. Coverage Pet Immunity 15 x 15 m, (49.2 x 49.2 ft) / 90° Up to 38 kg (85 lb) ELECTRICAL Internal Batteries Nominal Battery Capacity Battery Life (with LED on) Two 3V Lithium batteries, type CR-123A.
PAGE 3
. INSTALLATION 3.1 General Guidance 1. Keep away from heat sources. 2. Do not expose to air drafts. 3. Do not install outdoors. 4. Avoid direct sunshine. 5. Keep wiring away from power cables. 6. Do not install behind partitions. 7. Mount on solid stable surface. Figure 2. General Guidelines 3.
PAGE 4
1. 2. 3. Push in the direction of the arrow shown in the drawing to separate the detector from the bracket. Mount the bracket on the wall. Install new batteries. -ORIf batteries are already installed, pull the activation strip. 4. Mount the detector on the bracket by sliding it downward until a click is heard. Note: It is recommended to wait about 1 minute after battery removal, before inserting the new battery. Caution! Risk of explosion if battery is replaced by an incorrect type.
PAGE 5
3.6 Defaulting the Detector CAUTION! The defaulting process removes the device from the network and enables re-pairing. Separate the detector from the bracket to remove both batteries. (see Figure 7). 1. Press and hold down the detector’s tamper switch. 2. Insert one of the two batteries into the detector while observing battery polarity. 3. Release the tamper switch within 4 seconds (the LED blinks 3 times every 5 seconds). 4. To re-pair the detector, follow the instructions in section 3.4. 3.
PAGE 6
To satisfy RF exposure requirements, this device and its antenna must operate with a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.