User's Manual

This sensor is a Z-Wave enabled device (interoperable, two-way RF mesh networking technology) and is

fully compatible with any existing Z-Wave enabled network. The Z-Wave wireless communication

protocol allows for Z-Wave devices from different manufacturers to operate in the same Z-Wave

network. The sensor sends a Z-Wave message when motion is detected within its field of view.

For indoor use only

Operating Frequency: 908.42 MHz

Operating Range: Up to 100 feet line-of-sight

Operating Temperature: 0⁰C to 49⁰C

Battery: CR123A

Operating Principle: Passive infrared (PIR) technology

Wireless Motion Sensor

Installation & Operation Manual

Introduction

Product Specification

Motion Sensor Coverage Pattern

Solid regions in the pattern drawing

represent positive detection capability

of the sensor.

Side View

Top View

PAGE 1
Wireless Motion Sensor Installation & Operation Manual Introduction This sensor is a Z-Wave enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any existing Z-Wave enabled network. The Z-Wave wireless communication protocol allows for Z-Wave devices from different manufacturers to operate in the same Z-Wave network. The sensor sends a Z-Wave message when motion is detected within its field of view.
PAGE 2
Installation Notice: If you are installing an entire Z-Wave network for the first time, please refer to the installation guide provided by the manufacturer of your Z-Wave controller before installing the motion sensor. 1. Release cover tab to open the cover. 2. Insert a 3 Volt CR123A Lithium Ion battery into the battery compartment. The LED will start to flash slowly, indicating that the sensor has not yet been included in a Z-Wave network. 3.
PAGE 3
6. The sensor enters sleep mode when not in use. However, the sensor must be “awake” to receive messages from the controller. To activate “stay-awake mode”, remove the front cover. This will wake up the sensor. Leave the cover off to enable the controller to query the sensor for device specific information and capabilities. Federal Communications Commission Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1.