User's Manual

FLZB1-ECO

Flood Sensor

Installation Manual & User Guide

SPECIFICATIONS

Frequency: 2.4GHz Operating Temperature: 32°-120°F (0°-49°C)

Battery: Two,1.5Vdc AAAA Alkaline (3Vdc Nominal) Operating Humidity: 5-95% RH non condensing

Battery life: 4 years? Supervisory signal interval: 27 min(approx.)

Water Detect Depth: Minimum of 0.397mm (1/64”) Maximum current draw: 135mA during transmission

Party Certifications: FCC, IC, ETL, ZigBee 3.0

OPERATION

The FLZB1-ECO is a battery-powered sensor for home security or home automation applications. The FLZB1-ECO is

triggered by the presence of water in contact with the built in flood probes on the bottom of the case which

causes the FLZB1-ECO to transmit.

ENROLLING

To enroll the sensor, remove the top cover by prying off

at one of the tabs on either side. Set your panel into

program mode. Refer to your specific alarm panel

instruction manual for details on these menus. Once in

program mode, place the batteries into the sensor and

follow the instructions that appear on the panel. When

“Trip to Pair” appears on the screen, press the tamper

button to complete the enrollment process. See LED

section below for more information on initial power up

behavior.

NOTE: For best results, pair the device to your panel

before installation.

MOUNTING

The device is designed to be used on a flat surface without the need for mounting. A protective cover is supplied

which can be screwed down over the sensor to protect it from damage or from being moved from the set location.

A Universal Electronics Company

PAGE 1
FLZB1-ECO Flood Sensor A Universal Electronics Company Installation Manual & User Guide SPECIFICATIONS Frequency: 2.4GHz Battery: Two,1.5Vdc AAAA Alkaline (3Vdc Nominal) Battery life: 4 years? Water Detect Depth: Minimum of 0.397mm (1/64”) 3rd Party Certifications: FCC, IC, ETL, ZigBee 3.0 Operating Temperature: 32°-120°F (0°-49°C) Operating Humidity: 5-95% RH non condensing Supervisory signal interval: 27 min(approx.
PAGE 2
LED The Flood Sensor is equipped with an LED. On power up, the LED will stay solid for 2 seconds, then blink 3 times every 5 seconds (approx.) when not enrolled with a panel. If the sensor is already enrolled into a network, it will illuminate the LED for approximately 4 seconds and then turn off. REPLACING THE BATTERY When the battery is low a signal will be sent to the control panel. To replace the battery: 1) Remove the Flood Sensor from installation location by removing protective cover if necessary.
PAGE 3
C’et appareil est conforme la norme d'Industrie Canada exempts de licence RSS. Son fonctionnement est soumis aux deux conditions suivantes: (1) c’et appareil ne peut pas provoquer d'interférences, et (2) c’et appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement de la dispositif. This device complies with Industry Canada license-exempt RSS standard(s).