Installation Manual

CS-612 Flood and Freeze Sensor patent pending
Installation Manual
Operating Temperature: 32°-120°F (0°-49°C)
Operating Humidity: 5-95% RH non condensing
SPECIFICATIONS
Frequency: 345 MHz
Battery: One 3Vdc lithium CR2450 (620mAH)
Battery life: up to 5 years
Compatible with ClearSky
Det
ect Freeze at 41°F (5°C) restores at 45°F (7°C) Supervisory signal interval: 64 min(approx.)
Detect a minimum of 1/64
th
in of water
OPERATION
The CS-612 sensor is designed to detect water across the gold probes and will alert immediately when present. The
Freeze sensor will trigger when the temperature is below 41°F (5°C) and will send a restoral at 45°F (7°C).
ENROLLING
To enroll the sensor, set your panel into sensor learn mode. Refer to your specific alarm panel instruction manual
for details on these menus. The CS-612 locate the flood probes on the bottom of the sensor, you will need to bridge
two adjacent probes to initiate a transmission from the sensor.
1. To learn in as a flood/freeze sensor, bridge two adjacent probes to initiate a transmission from the sensor.
PLACEMENT
Place the flood detector anywhere that you wish to detect a flood or freezing
temperature, such as under a sink, in or near a hot water heater, a basement or
behind a washing machine. If you would like to make sure the flood does not
move from its intended location, use the provided sensor bracket and secure it
either to the floor or wall.
Testing the unit
By bridging adjacent probes, you can send a Flood/Freeze transmission. Bridge two adjacent probes using a
paperclip or metal object and remove it within 1 second. This will send a Flood/Freeze transmission.
REPLACING THE BATTERY
When the battery is low a signal will be sent to the control panel. To replace the battery:
1. Carefully remove the white rubber feet on the bottom of the flood detector.
2. Remove the 3 screws and open the case. Replace battery with a Panasonic CR2450 Lithium Battery
3. Replace the screws and rubber feet