ClearSky™ Remote Temperature Sensor A Universal Electronics Company Installation Guide © 2020 Ecolink Intelligent Technology Inc.
© 2020 Ecolink Intelligent Technology Inc.
Product Overview The remote temperature sensor is wall mountable remote sensor for use with any ClearSky™ compatible system. This sensor is ideal for remotely monitoring room temperature and reporting back to control panel or thermostat. The CS-502 also supports external NTC 10K ohm Type 2 probes. Features • • • • • Installation Instructions (1) Identify location for Remote Temperature Sensor. (2) Pair the sensor to the ClearSky™ compatible hub. Follow pairing instructions in the next section.
Pairing To pair the sensor, set your ClearSky Compatible Controller into sensor learn mode. Refer to your specific ClearSky Compatible Controller instruction manual for details on these menus. On the temperature sensor, locate the learn button above the external probe connector. Initiate pairing by pressing the the learn button. Repeat as needed by the ClearSky Compatible Controller. Unpairing Replacing the Battery When the battery is low a signal will be sent to the control panel.
FCC Compliance Statement DISCLAIMER AND LIMITATION OF LIABILITY This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
LIMITED WARRANTY RETURN POLICY This limited warranty is provided by Ecolink Intelligent Technology (“Ecolink”) to you as the original purchaser of the product. Ecolink warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of original purchase. The determination of whether the product is defective shall be made by Ecolink in its sole discretion with consideration given to the overall performance of the product.