Certification Exhibit FCC ID: Z9O-FAS1510 IC: 10060A-FAS1510 FCC Rule Part: 15.209, 15.231, 15.249 IC Radio Standards Specification: RSS-210 ACS Project: 11-2103 Manufacturer: UltraClenz, LLC Models: FAS1510-00, FAS1510-01, FAS1510-02, FAS1510-03, FAS1510-04 User Manual 3998 FAU Blvd.
Pa atient Safegu S uard Sy ystem (PSS)) Diispens ser Bea acon User’s U Guide DOC10 047 Revision 1 UltrraClenz, LLC
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC Table of Contents Revision History ......................................................................................................................................................... 3 1.0 Introduction to the System .................................................................................................................................. 4 2.0 System Components ............................................................
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC Revision History Revision Date By 0 3/14/12 MES Initial Release 1 08/09/12 DLS Corrected TOC and replaced FCC class A statement with class B statement Description Page 3
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC 1.0 Introduction to the System The Patient Safeguard System (PSS) was designed to help Healthcare Workers (HCW) protect their patients from the unintentional spread of pathogens. This is achieved by providing a tool to remind HCWs to perform hand hygiene when the opportunities are presented.
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC 3.0 Soap/Sanitizer Dispenser Beacon The soap/sanitizer dispenser beacon is installed next to a soap/sanitizer dispenser. In order for it to communicate with the dispenser, it is attached to the dispenser via a flat ribbon cable. The dispenser beacon will create an invisible “bubble” approximately 36 inches around the dispenser when the dispenser is activated.
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC 3.1 Adjusting the Soap/Sanitizer Dispenser Beacon Communication Range The dispenser beacon range of communication is adjusted during installation to maximize communication with the Healthcare Worker (HCW) badge. To adjust the communication range, remove the battery cover located on the front of the beacon using a #2 Phillips screwdriver (see Figure 3).
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC 4.0 How the System Works When a Healthcare Worker (HCW) begins their shift, they will attach an assigned badge to their clothing in a location above the waist that is clearly visible to HCW as well as others. The badge will be dormant with no blinking LED visible. This is normal because the badge will go into a “sleep” state to conserve battery power when not in use for a period of 30 minutes or more.
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC will change to the warning state. The badge will produce 3 quick beep tones with the second tone being lower in pitch than the first or third tones. This indicates successful communications between the badge and the bed beacon located within the patient zone. The badge’s red LED will then blink about once every 1.5 seconds.
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC 5.0 Installing the System 5.1 Soap/Sanitizer Dispenser Beacon Installation The soap/sanitizer dispenser beacon will be mounted on the wall next to the soap/sanitizer dispenser. It may be mounted on the left or right side of the dispenser but never below the dispenser. The dispenser beacon must know when the dispenser has been activated by the HCWs.
P Patient Safeg guard System m – Dispense er Beacon User’s Guide UltraC Clenz, LLC A Appendix A - System m Compone ent Care an nd Mainten nance C Cleaning the Componentts The dispense T er beacon sho ould be cleaned by wiping with a soft cloth. c A mixtu ure of 90% water w and 10% % chlorine (bleach) or wa ater and mild detergent (dish soap) ma ay be used. The T cloth sho ould be damp p but not wet. Only the e exterior of the e component may be clean ned.
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC Appendix B - Certification and Safety Approvals FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Patient Safeguard System – Dispenser Beacon User’s Guide UltraClenz, LLC Warranty This device is warranted against defective materials and workmanship for one year from the date of delivery. Equipment covered by this warranty will be repaired or replaced in the United States and Canada, WITHOUT CHARGE, except for shipping and handling, by our Factory Service Center.
