Ecobee 3 Remote Sensor Module (EBRSE3-01) User Manual | 250 University Ave | Suite 400 | Toronto, Ontario | M5H 3E5 Toll Free 1.877.932.6233, Int. 1.647.428.2220, support@ecobee.
Welcome! This guide will provide you an overview of how to install and operate your ecobee3 remote sensors. ecobee3 remote sensors are motion and temperature sensors that are compatible with your ecobee3 thermostat. These sensors will help you automate your comfort and energy savings. | 250 University Ave | Suite 400 | Toronto, Ontario | M5H 3E5 Toll Free 1.877.932.6233, Int. 1.647.428.2220, support@ecobee.
Description Model No. EBRSE3-01 Dimensions 44x44x20 mm without the stand. 53 mm tall when mounted on the stand Wireless band 915 MHz Power source CR2032 watch battery Operating conditions Operating Temperature: 0˚C to 40˚C Operating Humidity: 20% to 80% RH Installation Pull the plastic tab to power on the device. It will connect to your ecobee3 automatically. If the thermostat does not detect the sensor, simply remove the battery, wait two minutes, and replace.
After you’ve named your sensor, place it around your house at thermostat height; on a shelf or mounted to a wall avoid placing in areas with direct sunlight mount on an interior wall for more accurate temp reading. Use the double-sided tape or screw provided for wall mounting scenarios. The thermostat will alert you if the sensor has been placed too far away. Operation Once the sensor is paired with the thermostat, it will continue to transmit motion and temperature data to better inform your thermostat.
For more information on how to configure follow-me and autoaway Approvals This product was designed and built in accordance to RoHS directive 2002/95/EC and contains no hazardous substances as defined by this directive. Federal Communications Commission (FCC) Compliance Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1. this device may not cause interference, and 2. this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicable aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: 1.
EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some US states and Canadian provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. ecobee’s responsibility for malfunctions and defects in materials and workmanship is limited to repair and replacement as set forth in this warranty statement.