User's Manual

ManualsBrandsecobee ManualsElectronicsSmart Thermostat

| 250 University Ave | Suite 400 | Toronto, Ontario | M5H 3E5

Toll Free 1.877.932.6233, Int. 1.647.428.2220, support@ecobee.com

Technical manual

Ecobee4

GETTING STARTED

Welcome

Thank you for supporting ecobee, the Smart

Thermostat that provides your customers with

freedom and flexibility in managing their home

environment. The ecobee Smart Thermostat has

been designed in partnership with HVAC

contractors to ensure the installation process is

simple and efficient. This step-by-step

Installation Manual will walk you through all

aspects of the installation. To ensure an on-going

service relationship with your customers, please

your Contractor Portal.

The ecobee Team

Technical support

Our technical support team is available to

answer your

questions at 1.877-9-ecobee (1.877.932.6233),

or via

email at support@ecobee.com

Summary of content (6 pages)

PAGE 1
Technical manual GETTING STARTED Ecobee4 Welcome Thank you for supporting ecobee, the Smart Thermostat that provides your customers with freedom and flexibility in managing their home environment. The ecobee Smart Thermostat has been designed in partnership with HVAC contractors to ensure the installation process is simple and efficient. This step-by-step Installation Manual will walk you through all aspects of the installation.
PAGE 2
Before You Begin Approvals This product is intended to be installed by trained service professionals This manual explains the procedures for installing the ecobee Smart Thermostat. Please read it carefully before beginning the installation. For information on how to operate the ecobee Smart Thermostat, please see the ecobee User’s Manual.
PAGE 3
Specifications Temperature ranges Heat: 45 – 79°F (7 – 26°C) Cool: 58 – 92°F (14 – 33°C) Display: 40 – 100°F (5 – 37°C) Sensitivity: +/- 1°F (0.5°C) Equipment Interface Operating: -40o to 160oF (-40o to 70oC) Thermostat Operating: 32o to 130oF (0o to 55oC) Humidity Range Humidify: 20 to 50% R.H Dehumidify: 30 to 60% R.H Display: 0 - 90% R.H Sensitivity: +/- 2% R.H. Operating: 5 – 95% R.H non-condensing Dimensions Thermostat: 5.5”W x 3.25”H x 1”D (139.5mm H x 82.5mm W x 25mm D) Equipment Interface: 4.
PAGE 4
If after 2 hours the set point has not been met, the Thermostat will shutdown the heat pump and energize the auxiliary heat to meet the set point. This option should also be used for installation where the heat pump evaporator coil is downstream from the source of auxiliary heat. more than 10 minute without reaching the set point it will activate stage 3. A minimum run time of 10 minutes is used to ensure that proper circulation throughout the system and that minimum cycle times are maintained.
PAGE 5
List of Alerts Below is a complete list of alerts. Depending on your configuration, some of these may not apply to your system. • Low Battery • Furnace Air Filter • Ventilator Filter • UV Lamp • Humidifier Filter • Comms fault • Low Temp.
PAGE 6
if the Product: was operated/stored in abnormal use or maintenance conditions; 3-Year Limited Warranty ecobee warrants that for a period of three (3) years from the date of purchase by the consumer (“Customer”), the ecobee Smart Thermostat (excluding battery) (the “Product”) shall be free of defects in materials and workmanship under normal use and service. During the warranty period, ecobee shall, at its option, repair or replace any defective Products, at no charge for labour or materials.