Technical Specs

Familiar with this product
Products matching
product installation
technical specification
matters needing attention
Familiar with this product
Remote control
Light-sensing key: the remote control senses the key when the hand is near the light-sensing
area of the remote control about 10CM, and then sends a wireless signal out.
LED indicating lamp
The LED will go on for 2 seconds when the remote control senses the button
Battery compartment: The remote control needs 3 AAA batteries
Receiver
Battery box: Install 4 AA batteries;
Motor wire: connected to external motor
Working principle: the remote control send the wireless data TO Receiver
at the same time control motor
Products matching
1. The electric buzzer on the receiver box rings
2. The battery LED on the remote control displays twice, and the receiver box buzzer rings
once
3. Repeat the two steps three times, and the receiver box will ring once to indicate successful
pairing
Technical parameters:
Operating frequency: 2421MHz, a total of 1 channel
Modulation: GFSK
Transmission rate: 500kbps
Rf transmission power: 7DBM;
Operating temperature: -40℃ ~ 85℃;
Precautions for Use:
the products to avoid get wet in rain directly;
if the sensor is invalid, with the battery needs to wait for 20 seconds before induction, 20
seconds later the system will automatically reset.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular