User's Guide

ManualsBrandsEchostar Technologies ManualsElectronicsZigbee Door Sensor

DOOR/WINDOW SENSOR

QUICK START GUIDE

EchoStar Technologies L.L.C. Other products, brands, and companies

mentioned are the Trademarks of their respective owner(s). This

product is designed in the United States and manufactured in India.

p/n 209088

REGULATORY INFORMATION

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-

exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux

appareils radio exempts de license. L’exploitation est autorisée aux deux conditions

suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de

l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

If none of the remedies stops the radio interference, you should contact a licensed radio/

television technician, your satellite dealer, or visit SAGEbyHughes.com for assistance.

Product must be installed at least 20 cm (~8 inches) from typical person locations per

FCC RF exposure regulations.

Do not make changes or modiﬁcations to this equipment. This could void the user’s

authority to operate the equipment.

One year Limited Warranty. Limited Warranty details are

available at SAGEbyHughes.com/warranty.

LIMITED WARRANTY

Door/

Window

Sensor

Adhesive Fastener

(Double-sided tape)

(Qty. 3 pieces,

perforated)

Quick Start

Guide

PACKAGE CONTENTS

DOOR/WINDOW SENSOR

QUICK START GUIDE

For all your customer needs, go to SAGEbyHughes.com

Summary of content (2 pages)

PAGE 1
PACKAGE CONTENTS QUICK START GUIDE Copyright © 2016. EchoStar Technologies L.L.C., Englewood, Colorado 80112. All rights reserved. EchoStar is a registered trademark of EchoStar Technologies L.L.C. Other products, brands, and companies mentioned are the Trademarks of their respective owner(s). This product is designed in the United States and manufactured in India. DOOR/WINDOW SENSOR p/n 209088 Door/ Window Sensor Adhesive Fastener (Double-sided tape) (Qty.
PAGE 2
SETUP AND INSTALLATION This sensor allows you to set-up and control up multiple sensors using Zigbee signals that communicate with your SAGE Hub and that you can control and modify using your TV and mobile devices. To begin installing your SAGE Door/Window Sensor, follow the instructions below. 1 2 3 4 Using your SAGE remote, press HOME. Select Settings. Select Add Devices. Select Sensors. 5 6 Select Door/Window Sensor.