User's Manual

http://echoring.com

Revision: 1

7. Click the EchoRing tab and set the parameters to match the application data and the

wireless settings.

(A)

(B)

(C)

(D)

(E)

(F)

(G)

(H)

(I)

(A) Channel: the radio frequency to operate on.

TIP — To prevent interference, please ensure that any other radio transmitting device does not

operate on the selected channel. Please see to our product portfolio for tools that can help you

plan and enable coexistence of wireless products.

(B) TxPower: the power that each device shall transmit with.

TIP — Some milliwatt (mW) to decibel-milliwatts (dBm) conversions are 0dBm=1mW,

10dBm=10mW, 14dBm=25mW.

TIP — In order to make sure network is configured to allow application traffic’s cycle time,

packet length and data rate, it is recommended to start with minimum reliability first and then

go back and increase reliability after all parameters been set.

Value Function

1 (minimum) Minimal reliability measures, allowing higher performance

in terms of throughput and lower latency.

8 (maximum) Maximized reliability measures, often resulting in less

performance in terms of throughput and latency.

(D) Optimize For: by selection one of the three alternatives; Reliability (C), Packet

Length (F) and Latency (G), this one selected parameter will be given best possible

value automatically pending on the other parameters input value. Exact Config

disable this function.

5. Web-based Configuration Interface

Page 10 of 11