Installation Instructions

ManualsBrandsEC-LINK Automation ManualsElectronicsRFID Controller

Table Of Contents

ECLINK RFID EC-RF200 Reader

The EC-RF200 is a cost-efficient mid range reader licensed

according to ETSI, FCC and IC.Due to its very compact design, the

EC-RF200 is best suited for integration in machines as well as office

applications.

1、Characteristics:

• very compact

• can easily be integrated in machines

• internal antenna for applications with limitedspace

• external antennas makes numerous applicationpossible

• 0.5 W transmission power

2、Advantages

• One internal antenna (up to 30 cm)

• Three external antennas (SMA)

• Flexible through large external antenna portfolio

• Power over Ethernet

• For distributed identification points

• Small size and DIN rail mounting

• Easy integration in machines or cabinets

Summary of content (5 pages)

PAGE 1
ECLINK RFID EC-RF200 Reader The EC-RF200 is a cost-efficient mid range reader licensed according to ETSI, FCC and IC.Due to its very compact design, the EC-RF200 is best suited for integration in machines as well as office applications. 1、Characteristics: • very compact • can easily be integrated in machines • internal antenna for applications with limitedspace • external antennas makes numerous applicationpossible • 0.
PAGE 2
Technical characteristics Transponder protocol EPC class Gen2 (ISO 18000-6-c) UHF RFID antenna interface Antenna connection one internal antenna (up to 20 cm read range) 3 x SMA connector (50 Ohm) Transmitting Power max. 0.5 W configurable Frequency area 860 MHz ... 960 MHz (depending on specific reader) Interfaces • • RF-R200 (PoE) Ethernet (TCP/IP) 10/100 Mbit/s; Full Spec. 802.3 RF-R200 (module); RS 323 (serial), USB Performance Max.
PAGE 3
Norms & Safety Radio license EMC Safety RoHS compliant Extras 3、Interface definition： 1） Power interface, external DC9-36V power adapter 2） LAN interface, RJ45 connector definition 8PIN RJ45 connector definition Pin Definition Describe 1 TX+ Tranceive Data+ (Send signal+) 2 TX- Tranceive Data- (Send signal-) 3 RX+ Receive Data+ (Receive signal+) 4 NC NO Connect 5 NC NO Connect 6 RX- Receive Data- (Receive signal-) 7 NC NO Connect 8 NC NO Connect 3） ANT1，ANT2、ANT3 Interface, SMA c
PAGE 4
、LED display lamp： There is an LED display light on the front of the read-write host, which is defined as follows： Indicator light Led definition Blue light on -- indicates data upload (read label);If it is not on, it means there is no data upload 5、 caution： This device must be professionally installed This equipment does not allow any antenna to work with the transmitter; the permitted antenna type must be specified external antennas, for example (antenna name:Planar RFID antenna,Model:Ha-VIS RF-ANT-
PAGE 5
FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.