User`s guide

COMMUNICATION
EATON Powerware
®
BladeUPSt (12 kVA) User’s Guide S 164201649 Rev 2 www.powerware.com
91
X−Slot Cards
X−Slot cards allow the UPS to communicate in a variety of networking
environments and with different types of devices. The BladeUPS has
two available communication bays for any X−Slot card, including:
S ConnectUPS−X Web/SNMP Card − has SNMP and HTTP capabilities as
well as monitoring through a Web browser interface; connects to a
twisted−pair Ethernet (10/100BaseT) network. It has a built−in
switching hub that allows three additional network devices to be
connected to the network without the requirement of additional
network drops. In addition, a Powerware Environmental Monitoring
Probe can be attached to obtain humidity, temperature, smoke alarm,
and security information.
S Relay Interface Card − has isolated dry contact (Form−C) relay outputs
for UPS status: Utility failure, Low battery, UPS alarm/OK, or On
bypass.
S Modbus
®
Card − allows you to continuously and reliably monitor the
UPSs in your Building Management System (BMS).
S Industrial Relay Card (IRC) − is used to indicate the operating status of
the UPS system using the customer’s monitoring equipment. The
IRC uses four isolated normally−open or normally−closed dry relay
contacts to indicate the UPS status. Normal, Bypass, Battery, and
Alarm mode can be monitored.
S Modem Card − provides out−of−band remote notification and monitoring
using modem communication directly to cell phones and pagers.
See Figure 45 on page 87 for the location of the two X−Slot
communication bays.
Relay Interface Card
Modbus Card
Modem Card
ConnectUPS−X Web/SNMP Card
Industrial Relay Card
Figure 48. Optional X−Slot Cards