User`s guide

INSTALLATION
EATON Powerware
®
BladeUPSt (12 kVA) User’s Guide S 164201649 Rev 2 www.powerware.com
24
Installing the Input and Output Wiring
To install the parallel system input and output wiring:
1. Remove the four screws on the wireway access cover and retain.
Remove the cover and retain. See Figure 4.
Figure 4. Removing the Wireway Access Cover (Bottom Entry Shown)
2. If your rack is designed for bottom entry but you need to provide
top entry wiring, skip to Step 7 on page 26. Otherwise, continue to
Step 3.