Installation Manual

www.eaton.com IM02601001E 3-5
Mechanical Installation
PXM 2000 Series Transducer Installation
The PXM 2000 Series Transducer model is installed using DIN Rail Mounting.
Specs for DIN Rail Mounting: International Standards DIN 46277/3
DIN Rail (Slotted) Dimensions: 0.297244” x 1.377953” x 3” (inches)
7.55mm x 35mm x 76.2mm (millimeters)
Figure 3.9: DIN Rail Mounting Procedure Release Clip
1. Slide top groove of meter onto the DIN Rail.
2. Press gently until the meter clicks into place.
NOTES:
• To remove the meter from the DIN Rail, pull down on
the Release Clip to detach the unit from the rail.
• If mounting with the DIN Rail provided, use the Black Rubber
Stoppers (also provided). See gure on the right.
NOTE ON DIN RAILS:
DIN Rails are commonly used as a mounting channel for most
terminal blocks, control devices, circuit protection devices and
PLCs. DIN Rails are made of cold rolled steel electrolitically
plated and are also available in aluminum, PVC, stainless steel
and copper.