Installation Manual

www.eaton.com IM02601001E 3-1
Mechanical Installation
3 MECHANICAL INSTALLATION
Introduction
The PXM 2000 Series can be installed using a standard ANSI C39.1 (4” Round) or an IEC 92mm DIN
(Square) form. In new installations, simply use DIN or ANSI punches. For existing panels, pull out old analog
meters and replace them with the PXM Series meter. The various models use the same installation. See
Chapter 4 for wiring diagrams.
NOTE: The drawings shown below and on the next page give you the meter dimensions in inches and
millimeters (mm shown in brackets). Tolerance is +/- 0.1” [2.54 mm].
Figure 3.1: Meter Face
Figure 3.2: Meter Dimensions
Figure 3.3: Transducer Dimensions