Installation Manual
C-12 IM02601001E www.eaton.com
Conguration Management
Restart the Gateway Card
The Gateway Card restart push-button switch is located behind the hole in the card face plate
closest to the LED labelled DHCP. This switch is used to restart just the Gateway Card (not the
meter) should it be necessary to recover from some abnormal condition.
Momentarily press the switch by pushing a small device into the hole to activate the switch.
Reset Switch
100
Act
Status
DHCP
Ident
Power
Reinstalling the Meter
1. Turn power off to the 13 position connector. If an AUX cable was used then remove the 13
position connector. Else, disconnect the GND, L(+), and L(-) wires from the 13 position con-
nector.
Reset switch