Installation Manual
C-2 IM02601001E www.eaton.com
Conguration Management
Save/Restore Configuration Page
Replacing a Meter
If you are replacing a meter, you can use the backup le for your meter’s conguration to con-
gure the new meter with the same settings as the meter it replaced (see the previous section).
While following the installation instructions in the Quick Start Guide, instead of manually congur-
ing the meter on the bench, use the previous meter’s conguration le to set the meter param-
eters.
Monitoring Changes to the Conguration
The system log shows system events, such as changes to settings, rmware updates, and meter
restarts. Each event carries a time-and-date stamp and a severity level. You can print the log by
clicking the Print button; however, the printout contains a screen image, not the entire log. To
print an entire log you may need to use the scroll bar to reposition the log in the window and print
it in sections.
Note: You can tell who has made conguration changes to the meter from the log as it not only
logs changes but the IP address of the computer from which the changes were made.
System Log Page
Restoring the Meter to Factory Default Conguation
You can use the Gateway Card’s DIP switch to:
• Override the existing network settings and assign the local IP address 169.254.1.1.