Installation Manual
2-6 IM02601001E www.eaton.com
Overview and Specications
Utility Peak Demand
The PXM 2000 Series provides user-congured Fixed Window or Sliding Window Demand modes.
This feature enables you to set up a customized Demand prole. Fixed Window Demand mode
records the average demand for time intervals that you dene (usually 5, 15 or 30 minutes).
Sliding Window Demand mode functions like multiple, overlapping Fixed Window Demands. You
dene the subintervals at which an average of demand is calculated. An example of Sliding
Window Demand mode would be a 15-minute Demand block using 5-minute subintervals, thus
providing a new demand reading every 5 minutes, based on the last 15 minutes.
Utility Demand Features can be used to calculate Watt, VAR, VA and PF readings. Voltage provides
an Instantaneous Max and Min reading which displays the highest surge and lowest sag seen by the
meter. All other parameters offer Max and Min capability averaged over the demand period (meter)
or true Min and Max (Gateway Card)..
Specications
Power Supply
Range: 1 Option: Universal, (90 - 265)VAC @50/60 Hz or (100-370)VDC
4 Option: (18 - 60)VDC
Power Consumption: (5 to 10)VA, (3.5 to 7)W - depending on the meter’s hardware
conguration
Voltage Inputs (Measurement Category III) (See Accuracy Specications, later in this chapter.
Range: Universal, Auto-ranging:
Phase to Reference (Va, Vb, Vc to Vref): (20 to 576)VAC
Phase to Phase (Va to Vb, Vb to Vc, Vc to Va): (0 to 721)VAC
Supported hookups: 3 Element Wye, 2.5 Element Wye, 2 Element Delta, 4 Wire
Delta
Input Impedance: 1M Ohm/Phase
Burden: 0.36VA/Phase Max at 600 Volts; 0.014VA at 120 Volts
Pickup Voltage: 20VAC
Connection: 7 Pin 0.400” Pluggable Terminal Block
AWG#12 -26/ (0.129 -3.31) mm
2
Fault Withstand: Meets IEEE C37.90.1
Reading: Programmable Full Scale to any PT Ratio
Current Inputs(See Accuracy Specications, later in this chapter.)
Class 10: 5A Nominal, 10A Maximum
Class 2: 1A Nominal, 2A Maximum
Burden: 0.005VA Per Phase Max at 11 Amps
Pickup Current: 0.1% of nominal
Connections: O Lug or U Lug Electrical Connection (Diagram 4.1)
Pass-through Wire, 0.177” / 4.5mm Maximum Diameter
(Diagram 4.2)
Quick Connect, 0.25” Male Tab (Diagram 4.3)
Fault Withstand: 100A/10sec., 300A/3sec., 500A/1sec.