Installation Manual

www.eaton.com IM02601001E 10-23
Setup on the Web Server Pages
synch, an IP address of the NTP server should be set. When selecting NTP (Network
Time Protocol) as the Time Sync Source, at least one IP Address must be entered (as
many as three NTP server IP addresses may be entered). A list of public NTP servers is
available at: http://support.ntp.org/bin/view/Servers/WebHome.
Note: The Time Zone and Date format settings only affect logs and e-mails. The Preview
Date after changes are applied eld shows only
Clock Setup Edit Page
Hardware - System Firmware
The System Firmware page displays both the meter and gateway rmware version.
Firmware les can be downloaded from Eaton and the web page can be accessed
through the Firmware Conguration page. Click the Upgrade button to launch the
Firmware Conguration page.
CAUTION! DO NOT ATTEMPT TO LOAD AN OLDER VERSION OF THE FIRMWARE.
THIS CAN CAUSE THE METER TO NO LONGER FUNCTION. SHOULD THIS OCCUR,
YOU MAY BE ABLE TO RESTORE THE METER TO WORKING ORDER BY RESETTING
IT TO THE FACTORY DEFAULT STATE (SEE “RESTORING THE METER TO FACTORY
DEFAULT CONFIGUATION” ON PAGE C-2).
To download rmware trom the Firmware Conguration Page:
1. Select the Reboot when complete checkbox.
2. Click the new rmware image link, which will direct the meter to the eaton.com website
where rmware les are stored.
3. Select the rmware type from the list.