Installation Manual
www.eaton.com IM02601001E 10-17
Setup on the Web Server Pages
• The Enabled check boxes activate the Above and Below settings. When active, the
output is triggered for when that condition occurs. Once active, you can click any of
the Setpoint and Hysteresis elds and edit their contents.
Hardware Limits Edit Page
You can use the Digital Input Setup Edit page to congure the relay inputs. You can as-
sign labels for the open and closed states as well as the accumulator. You can also dis-
able/enable the accumulator as well as the set the state of the Trigger Input: Disabled,
Open to Close, Close to Open, or Any Transition.
You can use the digital inputs to accept pulses from gas or water meters. The divisor is
a compression factor you can use to keep the results within the meter’s ability to report.
Without the compression factor, the accumulator might roll over either too much or too
rapidly and lose history.