Cut Sheet

Volume 8—Sensing Solutions CA08100010E—November 2012 www.eaton.com V8-T6-19
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6.2
Conveyor Sensor Systems
200 Series Zero Pressure Accumulation
Accessories
Basic and Progressive Logic Sensors
Cables, Zone Jumpers and Power Supplies
Note
1
See Page V8-T6-28 for more details.
Description Length Notes Catalog Number
Singulate Release Cable
This cable is connected to the last zone and allows singulate or
slug discharge control from an external system.
2m Release only BUS266REL-01B1
Both release and power connections are provided. If
the power connection is used, a power supply cable is
not needed
BUS266REL-02B1
Zone Jumper
A zone jumper is required when a zone is skipped to allow
communications to continue through the unused zone.
5 in — QDJU266A-01B1
Power Supply
A 100W power supply designed for use with the 200 Series
system. On systems with zone lengths up to 48 in, it will power
up to 110 sensors with 0.67W solenoids (74 if the solenoids are
1.2W; 38 if the solenoids are 2.4W).
—— PS256A-01B1
1
PS256A-04B1
1
Power Supply Cable
This cable allows the power supply to be connected to any zone,
while allowing use of that zone. For best results, the power
supply cable should be connected at the center of the zones
being powered.
2m — BUS266PWR-01B1
50 ft — BUS266PWR-5001B1
Buss Link Cable
This cable allows two sections of buss harness to be connected
together. NOTE: 10 ft versions of buss harness have this
connector built-in.
10 cm Passes power and ZPA signals BUS266LINK-01B1
10 cm Power isolation version. Passes ZPA signals but
isolates power. This allows for connection of more
than one power supply to a long section of ZPA
conveyor.
BUS266ISO-01B1
This cable allows two sections of buss harness to be connected
together. DC power is passed through the connection.
3m Passes power only BUS266JUMP15-01B1
This cable allows two sections of buss harness to be connected
together. Both DC power and the ZPA signal is passed through
the connection.
3m Passes power and ZPA signals BUS266JUMP15-02B1
Power Curve Module
Allows ZPA through a powered curve that is not divided into ZPA
controlled zones.
All required wiring is included.
— Install adjacent to the 200 Series sensor at the
powered curve infeed. All required wiring included.
1451BSR1216
Singulate Release
Cable
Zone Jumper
Power Supply
Power Supply Cable
BUS266LINK-01B1
BUS266ISO-01B1
BUS266JUMP15_
Power Curve Module