RFN SelectComm-MRB User’s Guide Document Number XXXX Revision 1 Cooper Power Systems 20201 Century Boulevard, Suite 250 Germantown, MD 20874 USA www.cooperpowereas.
Contents 1 About the RFN SelectComm-MRB ..................................................................................................... 3 2 Regulatory Notices ............................................................................................................................... 4 3 RFN SelectComm-MRB Specifications ..............................................................................................
1 About the RFN SelectComm-MRB The RFN SelectComm-MRB is a radio communications device designed for use in Cooper Power System’s EkaNet RF mesh networks. It has no sensor or meter directly associated with it, and can be used in a variety of applications to extend the range and reliability of the RF mesh network. It is designed to be used in Cooper’s LCR, Relay, Gateway, Energy Harvesting Relay, and Field Tool products. The RFN SelectComm-MRB provides a 915 MHz radio interface.
2 Regulatory Notices Warning The Original Equipment Manufacturer (OEM) must ensure that FCC Labeling requirements are met. This includes a clearly visible label on the outside of the OEM enclosure specifying the Cooper Power Systems FCC identifier (FCC ID: P9X-RFNSCOMMMRB) and IC Number (IC: 6766A-RFNSCOMMMRB) as well as the FCC Notice below. This device complies with Part 15 of the FCC Rules.
Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operate in conjunction with any other antenna or transmitter.” Warning As such, the radio component of this device is intended only for OEM integrators under the following two conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users.
3 RFN SelectComm-MRB Specifications Radio Specifications Operating frequency 902.75 – 927.25 MHz Reliable data transmission Error detection, correction and retransmission RF output power 30 dBm to -20 dBm Data rate 76.8 kb/s, 153.6 kb/s Receiver sensitivity -101 dBm (@ 1% PER, 76.
Cooper Power Systems 20201 Century Boulevard, Suite 250 Germantown, MD 20874 USA www.cooperpowereas.