Hardware Setup Guide Eka Systems Inc. 444 N Frederick Ave • Suite 315 • Gaithersburg, MD 20877 Phone 301.990.3450 • Fax 301.990.
STEP 1 Identify the hardware Identify the following components that are part of the BlueMeter Hub package. § § § § § BlueMeter hub, with its attached Bluetooth dongle. BlueMeter Module for the electric meter. 5V DC adapter to power the BlueMeter hub. CD media with the BlueMeterTM Network Manager software. BlueMeterTM Network Manager User Guide. STEP 2 Configuring the IP Address on the Hub For connecting the Hub on to a LAN. Follow the procedure outlined in this step. Components required: 1.
4. Connect the DC power cable (included) to the Hub. 5. Connect the other end of the DC power cable to the power outlet. 6. Connect the null modem cable to the available serial port on the PC running the Network Ma nager and the ‘COM2’ port on the Hub. (Null Modem cable not included). 7. Follow the steps outlined in Chapter 2 of the BlueMeter Network Manager User Guide to add a Hub using a serial port connection as shown in the picture below. 8.
on the PC. Please note that the serial port on the hub is configured to communicate at 9600 baud. FCC Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.