Eka 900SiP User’s Guide Document Number XXXX Revision 1 Eka Systems, Inc. 20201 Century Boulevard, Suite 250 Germantown, MD 20874 USA www.ekasystems.
Contents 1 About the Eka 900SiP Radio Module.................................................................................................... 3 2 Regulatory Notices................................................................................................................................. 4 3 Eka 900SiP Radio Module Specifications ............................................................................................
1 About the Eka 900SiP Radio Module The Eka 900SiP radio module is designed for use in Eka’s 915 MHz wireless products. it provides a 915 MHz radio interface for communicating on an EkaNet network. The 900SiP radio module operates from a power source of 2.5V to 3.6V, received from the host device. The radio module operate in the 915 MHz license-free band. Eka 900SiP Nodes are fully compatible with EkaNet mesh network hardware, protocols and operations. Two radio transmission data rates are available: 76.
2 Regulatory Notices Warning The Original Equipment Manufacturer (OEM) must ensure that FCC Labeling requirements are met. This includes a clearly visible label on the outside of the OEM enclosure specifying the Eka Systems FCC identifier (FCC ID: P9X-900SIP) and IC Identifier (IC: 6766A-900SIP) as well as the FCC Notice below. This device complies with Part 15 of the FCC Rules.
Warning To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 22.4 cm from all persons and must not be co-located or operate in conjunction with any other antenna or transmitter.” As such, the radio component of this device is intended only for OEM integrators under the following two conditions: The antenna must be installed such that 22.4 cm is maintained between the antenna and users.
3 Eka 900SiP Radio Module Specifications Radio Specifications Operating frequency 902 – 928 MHz Reliable data transmission Error detection, correction and retransmission RF output power 27 dBm to -20 dBm Data rate 76.8 kb/s, 153.6 kb/s Receiver sensitivity -98 dBm (@ 0.1% BER, +25° C Range (w/ omni antenna) Outdoor < 1,000 m (3200 ft) Indoor 75 – 150 m (225 – 490 ft) Mode Frequency hopping spread spectrum Mechanical Specifications Weight unavailable Dimensions 27mm x 27mm x 3.
20201 Century Boulevard, Suite 250 Germantown, MD 20874 USA www.ekasystems.
