FLEXTRAY FLEXTRAY™ - Installation Eaton D-49 B-Line series Cable Tray Systems
FLEXTRAY™ - Installation Flextray Cutters • Exclusive, patented CLEANSHEAR™ cuts tray fast • No sharp edges Part Number • Designed specifically for cutting Flextray • Safely cut and bend Flextray into any configuration CLEANSHEAR Description Qty./Box Wt./Box lbs. CLEANSHEAR Cutting Tool 1 (kg) 4.3 (1.95) Patented 1 Face tray up. Slide cutter next to vertical wire and cut. 2 Turn tray to the side with open side facing you. Repeat step 1 to cut wire.
FLEXTRAY™ - Installation Angular Bolt Cutter Part Number Description Qty./Box Wt./Box lbs. (kg) WB30BC Bolt Cutter 1 6.8 (3.1) WB30RB Replacement Blade 1 1.3 (0.6) WB30RB Replacement Blade WB30BC Angular Bolt Cutter Cut and remove each wire as illustrated below. Follow cutting pattern and blade positioning. Placing Flextray open side down provides the optimum cutting angle. Completely adaptable, the Flextray system is designed to accommodate jobsite changes.
FLEXTRAY™ - Installation 90° Horizontal Bends (Short Radius) • Make your own field cut horizontal bends using CLEANSHEAR™ to make safe, smooth cuts • Can be made from any tray width and depth with any available finish • SUPT WASHER & FTHDWE 1/4 hardware may be used on bottom of tray instead of WASHER SPL KIT where desired 2” (50mm) Tray Width Flextray Depth (mm) Required Hardware Description Quantity in.
FLEXTRAY™ - Installation 90° Horizontal Bends (Short Radius) • Make your own field cut horizontal bends using CLEANSHEAR™ to make safe, smooth cuts • Can be made from any tray width and depth with any available finish • SUPT WASHER & FTHDWE 1/4 hardware may be used on bottom of tray instead of WASHER SPL KIT where desired 16” (400mm) Tray Width Flextray Depth (mm) Required Hardware Description Quantity in.
FLEXTRAY™ - Installation 90° Horizontal Bends (Long Radius) • Make your own field cut horizontal sweeps using CLEANSHEAR™ to make safe, smooth cuts • Can be made from any tray width and depth with any available finish • Cut as many segments as required to control sweep radius (use chart for recommendations) • One (1) WASHER SPL KIT is required to connect each cut segment minus one, this segment uses one (1) SPLICE BAR, two (2) FTHDWE 1/4 and two (2) BTM WASHER • Illustration shown below is for a 8” (200mm)
FLEXTRAY™ - Installation Reducers Large Flextray Width WASHER SPL KIT Component Qty. FTHDWE 1/4 & BTM WASHER Straight Reducers SPLICE BAR (SR) in.
FLEXTRAY™ - Installation Horizontal Tees (and crosses) • Cut wire side sections as shown in the illustration below (Illustration is for a 8” (200mm) width) • 1.5” deep FLEXTRAY has only one (1) side wire 2” deep FLEXTRAY has two (2) side wires - shown 4” deep FLEXTRAY has three (3) side wires 6” deep FLEXTRAY has four (4) side wires • For crosses, duplicate process on opposite side Tray Width in. (mm) WASHER SPL KIT Qty.
