User Manual

1.
2.
3.
4.
5.
6.
Remove cap portion of EZ-Cap Pre-wire Installation Kit
from ceiling or wall by screwing cap counter clockwise
by hand. You now have access to low voltage wire.
( see figure I right )
Drill desired hole size in center of Cap.
( see figure J below )
Feed wire through the hole in cap from rear. Screw cap
clockwise into wire outlet hole until it fits flush against
drywall. ( see figure K below )
If speaker mount is large enough to cover hole in drywall,
steps 2 and 3 can be skipped.
Mount speaker for desired look.
You have now completed the Surface Mount Installation.
EZ-CAP Surface Mount Speaker Installation Guide
General Reference figure below
24” Center Mark Break Point 16” Center Mark Bridge Wire Inlet Holes Wire Cavity
Figure I
Figure J Figure K
EZ-CAP
TM
A Smart New Pre-Wire Solution www.ez-caps.com • Phone [phone]
Pre-Wire Installation Kit
The Patented EZ-Cap Pre-Wire Installation Kit will
dramatically change the low voltage pre-wire industry.
The purpose of the kit is to allow easy access to the
wiring for customers who wish to install speaker
components sometime in the future while
remaining inconspicuous when not in use.
P O Box 2108 • Jefferson City, MO 65102
Phone: [phone] • Fax: [phone]
www.ez-caps.com • E-Mail: [e-mail]
EZ-CAP
TM
Enterprises, LLC