User's Manual

Installation Manual

This module is to be installed only by the professionals and used only with any product produced by

Kodak. When this module is installed in a product, we shall consider the following points;

1. Since “

BTMC2.0EDR-EP02A” owns its FCC ID Number/IC Number, we shall affix an

exterior label on the outside of the product if the FCC ID/IC Number is not visible. The

exterior label shall use wording such as either ”Contains Transmitter Module FCC ID:

PA4V610 /IC Number: 1016B-V610” or “Contains FCC ID: PA4V610/IC: 1016B-V610”.

2. “

BTMC2.0EDR-EP02A” complies with requirements of sub-sections 15.19(a)(3) in FCC

Rules Part 15 Subpart C. The manual statement (15.19 (a)(3) is included User Guide of the

product.

3. “

BTMC2.0EDR-EP02A” is to be installed only by the professional line operator as shown in

following pictures. (Fig1, 2, and 3)

Fig1. Rear side of “

BTMC2.0EDR-EP02A”

Fig2. Front side of “

BTMC2.0EDR-EP02A”

BT Module

Antenna

PAGE 1
Installation Manual This module is to be installed only by the professionals and used only with any product produced by Kodak. When this module is installed in a product, we shall consider the following points; 1. Since “BTMC2.0EDR-EP02A” owns its FCC ID Number/IC Number, we shall affix an exterior label on the outside of the product if the FCC ID/IC Number is not visible.
PAGE 2
Fig3. “BTMC2.0EDR-EP02A” be equipped for a digital camera (example) The following statements should be included in User guide of installed product: FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65.