User's Manual
Wireless Laser Mouse User Manual
Feature
1. 2.4G frequency,digital cordless with distance up to 5-7meters
2. Internal 65,000 group ID code,plug and play
3. 800/1200/1600DPI, high-precision and high- stabilization
4. Self contained power switch, low power consumption,automatic sleeping function.
Compatible
IBM PC and compatibles,Win98SE/Me/2000/XP/VISTA operating system,no need driver
Installation
1, Take the receiver from the packing,plug onto the USB port of PC or BOTEBOOK’,after a
few minutes,the software of receiver will be installed automatically. If it is Win98SE system,
you need to follow the prompting frame to finish the installation.
2, Open the battery cover,put into 2 AAA rechargeable batteries(Pay attention to the battery
polarity)
3, Turn on the switch of the mouse,wheel light will flicker a few seconds
4, You can use it till you can find the curser on the PC screen
Reset
Wireless mouse’s remitter and receiver has storage the same group ID code,It will make sure
the mouse remit and receive the corresponding data. If any of ID code for each group disappear
or disaffinity, the mouse will not work,and you need to reset it.
1, Insert the receiver on the USB port, the indicator light will flicker,then put battery into
mouse,turn on the mouse.
2, When the indicator light flickers,press the right key of emitter,then press the middle key
for three seconds, emitter will emit corresponding code,
then the connection finished.
3, Move the mouse and you will find the curser on the PC screen.
Note:Don’t always press the ID switch,unless the ID code will be reset and you need to
reconnect the mouse.
CPI
800/1200/1600CPI can shift be adjusted, the DPI will change if you press the switching on the
top of the mouse.
Tips
1. The work distance is about 5-7 meters, but it will be less if there is any barrier.
2. This mouse uses laser light as transfer checking, it comply with correlative safe
standards, please do not look into the bottom of the mouse directly.
3. It has automatic sleeping function, the mouse will sleep if you don’t use it for about 10
minutes, just press any key to rouse it.
4. Take off the battery if you don’t use the mouse for a long time.
5. Change the battery in time please.
6. Automatic ID code memory function,just reconnect it if the ID code reset.
7. You can store the receiver in the emitter’s abdomen storage compartment if you don’t
use it.