M30 MEASUREMENT MICROPHONE Follow us on social media @EarthworksAudio For more information, please visit earthworksaudio.com or call 1-603-654-2433.
M30 MEASUREMENT MICROPHONE Thank you for purchasing the Earthworks M30 Measurement Microphone YOUR PURCHASE INCLUDES 1 Earthworks M30 1 Microphone Clip 1 Calibration Adapter 1 Calibration Chart 1 Frequency Response Data Sheet (Available Upon Registering Your M30) GETTING STARTED The M30 is a condenser microphone with active electronics. This meansm ` Its output level will be naturally higher than many of the dynamic microphones that it may be replacing.
M30 MEASUREMENT MICROPHONE ) Avoid extreme heat and condensing humidity. Allow the microphone to warm up when bringing it in from the cold. ) Rough handling may damage the microphone even if no markings are visible. ) When not in use, keep the microphone in its case. IMPORTANT NOTICES The small tip on many of our microphones allows them to capture the highest frequencies of your sound. Please be gentle and considerate when handling the microphones with these tips.
M30 MEASUREMENT MICROPHONE % Your recording space is at room temperature and free of dust. If your issue persists after checking, please contact us via our website. SPECIFICATIONS Frequency Response 3Hz to 30kHz Polar Pattern Omnidirectional Sensitivity 34mV/Pa (Typical) Power Requirements 24-48V Phantom, 10mA Peak Acoustic Input 140dB SPL Output XLR-3 Output Impedance 600Ω, balanced between pins 2 & 3 Noise 20dB SPL (A weighted) Dimensions 9 x .860 in.
M30 MEASUREMENT MICROPHONE WARRANTY All Earthworks® products carry a limited warranty (parts and labor). Please register your warranty at: earthworksaudio.com/ register. If you have any problems with your Earthworks products, please contact our warranty/repair department by email at: service@earthworksaudio.com. NOTE This warranty only applies to Earthworks microphones purchased brand new. For microphones purchased/received second-hand, please contact us via our website. 37 Wilton Rd.